sheet 3
TRANSCRIPT
Slide 1
MACHINE DRAWINGByDr. Srinu GangoluDEPARTMENT OF MECHANICAL ENGINEERING K.L. UNIVERSITY21st Jan 2015Lecture 5: Sheet No-3
Orthographic ProjectionProjection is defined as representation of an object on two dimensional plane
The (V.P) vertical and (H.P) horizontal planes are also called principle planes
K. Venkata Reddy : Engineering Drawing, Second Edition, 2008
K. L. Narayana: Machine Drawing
1. View in the direction a = front view2. View in the direction b = top view3. View in the direction c = left side view 4. View in the direction d = right side view5. View in the direction e = bottom view 6. View in the direction f= rear viewK. Venkata Reddy : Engineering Drawing, Second Edition, 2008
Projection of Points
K. Venkata Reddy : Engineering Drawing, Second Edition, 2008
Try this
K. Venkata Reddy : Engineering Drawing, Second Edition, 2008
Sheet No-3
The figure below shows the isometric views of machine components and their view from the front, the view from above and the view from the right. (Draw the views)
K. L. Narayana: Machine Drawing
XYZ
XZIs it over??XY
Is it over??YZ
The figure below shows the isometric views of machine components and their view from the front, the view from above and the view from the right. (Draw the views)
K. L. Narayana: Machine Drawing
K. L. Narayana: Machine Drawing
Draw (i) the view from the front, (ii) the view from above and (iii) the view from the right, of the objects shown in Figures.
K. L. Narayana: Machine Drawing
Submission of sheetsSheet -1: after 21st Jan 2015- 5 Marks
Sheet -2: on 21st Jan 2015-10 Marks, After 21st Jan 2015-7 Marks
Sheet 3: on 28th Jan 2015-10 Marks
Do not forget to write ALL DIMENSIONS ARE IN MMDo not forget to give 1st angle projection symbol