short cut or long road? equivalence, international standards and the gats julia nielson, oecd wto...
TRANSCRIPT
Short cut or long road? Equivalence, international standards and the GATS
Julia Nielson, OECD WTO Workshop on Domestic RegulationGeneva29 March 2004
Structure of presentation
Introduction Key terms Key legal provisions
Equivalence Article VI.6 (verifying competence) Recognition (GATS Article VII) Guidelines on Mutual Recognition in the Accountancy Sector Accountancy Disciplines Mutual Recognition Agreements (MRAs)
International standards Article VII.5 Article VI.5 Accountancy Disciplines
Concluding thoughts
Introduction – key terms
Equivalence Where a host country’s regulatory goals
are addressed by home country regulation, the host country should accept the home country’s regulation as equivalent.
Where aspects of the regulatory goals are not met, host country can set additional requirements (compensatory measures) E.g., local knowledge (seismic forces in
architecture) or scope of licensed activities
Introduction – key terms
Equivalence Recognition is based on the principle of
equivalence is the basis for recognition Usually accorded bilaterally or plurilaterally, or unilaterally
Equivalence, and recognition, are not harmonisation Often seen as a way of avoiding harmonisation of
requirements Although could be argued that some “essential
harmonisation” facilitates establishment of equivalence and thus recognition
Introduction – key terms
International standards By contrast, these are an attempt to develop a
common understanding on a desirable set of standards for a given product or service.
More of a collective act whereby a group of countries – or professional bodies – agree to adhere to a set of standards which they believe meet their regulatory objectives.
Key legal provisions
Equivalence GATS Article VI.6 (adequate procedures to verify the
competence of professionals from any other WTO Member)
Article VII (Recognition) Guidelines for Mutual Recognition in the Accountancy
Sector Accountancy Disciplines (regarding qualification
requirements) International standards
GATS Article VII (Recognition) GATS Article VI.5 Accountancy Disciplines (regarding technical standards)
Structure of presentation
Introduction Key terms Key legal provisions
Equivalence Article VI.6 (verifying competence) Recognition (GATS Article VII) Guidelines on Mutual Recognition in the Accountancy Sector Accountancy Disciplines MRAs
International standards Article VII.5 Article VI.5 Accountancy Disciplines
Concluding thoughts
Equivalence
First, have very basic general obligation Article VI.6 Where specific commitments in professional
services are undertaken, each member shall provide for adequate procedures to verify the competence of professionals from any other member. Procedures, not substance “Adequate” is not defined MFN – must have a procedure for all other members Does not require the establishment of equivalence
between home and host country requirements, nor recognition.
Equivalence
Article VII (Recognition) Permits derogation from MFN by allowing
members to recognise the education or experience obtained, requirements met or licenses and certifications granted in some members but not others. Acknowledges that recognition will be accorded
unilaterally, bilaterally or plurilaterally and that a requirement to extend recognition MFN would result in little recognition being granted and few MRAs.
Recognition happens outside the GATS.
Equivalence
Article VII cont’d However, several important limits to this derogation:
Must afford adequate opportunity to other interested members to negotiate their accession to the agreement or to negotiate a comparable one;
To facilitate this, members must Notify existing, new or modified recognition measures to the CTS Notify CTS of opening of negotiations of an MRA as far in
advance as possible. Cannot discriminate amongst WTO Members in the
application of standards or criteria for recognition I.e., can apply whatever standards you like, but they must be the
same for all members Does not imply that all WTO members will meet those standards,
however.
Equivalence
Article VII cont’d GATS applies to measures taken by governments
Applies to non-governmental bodies in the exercise of powers delegated by the central, regional or local governments and authorities.
What is the status of recognition agreements which are are reached between professional bodies? Depends on whether exercising delegated powers Not clear how specific those delegated powers need to be to bind states
at international law Some agreements have been notified under GATS Article VII, others
not. Some notified but states that is not a a government-to-government
agreement. Some agreements notified under GATS Article V (Regional
Integration) Do Article VII disciplines apply?
Equivalence
Article VI.6 and Article VII are different MFN requirement vs MFN derogation Recognition vs “adequate procedures to verify
competence”
But are linked – 1995 Decision on Professional Services: In
making recommendations on accountancy shall concentrate on: Facilitating the effective application of Article VI.6
by establishing guidelines for the recognition of qualifications
Equivalence
WTO Guidelines for Mutual Recognition Agreements or Arrangements in the Accountancy Sector
Completed May 1997
Provide practical advice for governments or other negotiating entities entering in MRAs on accountancy services. Voluntary and non-binding Acknowledges that differences mean that recognition will
continue to be bilateral, not multilateral But hope that bilateral recognition agreements will increase,
expanding recognition more broadly.
Equivalence
Guidelines on MRAs cont’d Cover both process for negotiating and substance of
MRAs, e.g., Process - what should be included in notifications of
opening and closing of negotiations, follow up actions, encouraged to develop single negotiating entity.
Content – what should be covered e.g., participants, purpose and scope, conditions (including at sub-national level), qualifications (minimum levels of education, experience), registration mechanisms, implementation. When compensatory measures might be required (e.g.,
knowledge of local law) and what they entail (exams, training).
Also procedures – contact points, length (exams arranged with reasonable periodicity), documentation requirements, fees (in proportion to costs incurred), appeals.
Equivalence
Finally, have the Accountancy Disciplines 1995 Decision on Professional Services
mandates the implementation of the work program to develop disciplines under Article VI.4, with priority to the accountancy sector Disciplines were finalised in December 1998 Enter into force at the end of the current round of
negotiations Apply only to accountancy sector and only
where specific commitments have been made
Equivalence
Accountancy Disciplines cont’d Under VI Qualification Requirements
A member shall ensure that its competent authorities take account of qualifications acquired in the territory of another member, on the basis of equivalency of education, experience and/or examination requirements [paragraph 19].
Equivalence
Accountancy Disciplines cont’d That is, regulators are obliged to take account of
qualifications already received in the home country and to modify any additional requirements imposed upon services suppliers accordingly. This is only to “take account of” and only on the basis of
equivalency – it does not prejudge the regulator’s decision regarding the extent of equivalency and does not require recognition.
If regulator doesn’t feel that regulatory goals are met, can still impose additional requirements (complementary measures).
Equivalence
Accountancy Disciplines cont’d Generally, qualification requirements must be no
more trade restrictive than necessary to fulfil a legitimate objective. Further, specifically, must take account of accountancy
qualifications already earned To what extent are they equivalent with own
requirements/qualifications? Any additional steps to meet equivalence with the required
qualifications (e.g., additional training) should also not be more trade restrictive than necessary to fulfil a legitimate objective Can require additional training, but not back to pre-school.
Equivalence
Accountancy Disciplines cont’d Members note the role which mutual recognition
agreements can play in facilitating the process of verification of qualifications and/or in establishing equivalency of education [paragraph 21].
MRAs establish equivalency of qualifications already earned And thus can facilitate assessment of whether measures
relating to qualification requirements are the least trade-restrictive necessary to fulfil a legitimate objective. i.e., Indirectly could also contribute to judgement about extent to
“necessity test” is being met. As a practical matter, existence of MRAs means that the
necessity test question is unlikely to arise. Also, Article VI.6 also unlikely to arise where have MRA.
Equivalence
MRAs Obviously very useful in meeting GATS requirements and facilitating
trade But progress has been modest – although many are works in progress
(watch this space) Most agreements between developed countries
Tend to reflect regional or historical ties Most in the already internationalised professions
E.g., accounting, architecture, engineers, nurses Extent of recognition varies
Automatic recognition; partial recognition plus bridging courses; recognition subject to further assessment and testing; a degree of facilitation; cooperation and dialogue.
Most progress made where professions has taken the lead While some RTAs encourage the development of MRAs, generally leave
them to be negotiated subsequently by competent authorities
Equivalence
MRAs - why limited progress? Wide range of practices and cultural assumptions Fear of loss of regulatory sovereignty Absence of formal licensing or qualification systems in some
countries Absence of recognition frameworks or experience MRAs often led by industry associations – may be lacking or
not interested in facilitating access Lack of awareness in the professions of the benefits of MRAs
Resource intensive and complex negotiations Lack of incentive to negotiate MRAs in absence of real market
access interests (or relevant commitments)
Equivalence
Summary Where have an MRA
Have clearly met requirement to take account of equivalence of qualifications already earned (AD) As a practical matter avoid necessity test and Article VI.6
But relatively few MRAs out there and prospects for progress difficult
Demand driven and resource intensive Guidelines on MRAs in Accountancy Sector could help by
encouraging development of more, or simply more consistent, MRAs Could these guidelines be used as a template for the development of
MRAs in other professions? International standards might also facilitate the development
of more MRAs.
Structure of presentation
Introduction Key terms Key legal provisions
Equivalence Article VI.6 (verifying competence) Recognition (GATS Article VII) Guidelines on Mutual Recognition in the Accountancy Sector Accountancy Disciplines MRAs
International standards Article VII.5 Article VI.5 Accountancy Disciplines
Concluding thoughts
International standards
Article VII.5 (Recognition) Wherever possible, recognition should be based on
multilaterally agreed criteria. In appropriate cases, Members are to work in
cooperation with relevant inter-governmental and non-governmental organisations towards the establishment and adoption of common international standards and criteria for recognition and common international standards for the practice of relevant services trades and professions.
International standards
Article VII.5 (Recognition) Does not require the use of
international standards In appropriate cases, wherever possible
Acknowledges the role of non- and inter- governmental bodies Relevant bodies are those whose
membership is open to at least all WTO members.
International standards
Article VI.5 (Domestic Regulation) In determining whether a member is in conformity
with the obligation not to apply licensing and qualification requirements and technical standards that nullify or impair specific commitments, account shall be taken of international standards of relevant international organizations applied by that member.
Same definition relevant organisations as in Article VII.5 Introduces the idea that international standards are
relevant to the assessment of whether a measure is more trade restrictive than necessary
But, unlike agreements in goods (TBT, SPS), it does not create a presumption that a measure in conformity with international standards is presumed to be necessary.
International standards
1995 Decision on Professional Services draws these two elements together
In drawing up disciplines on accountancy, asked to concentrate on The use of international standards and, in
doing so, [to] encourage the cooperation with the relevant international organizations as defined in Article VI.5 (b), so as to give full effect to Article VII.5
International standards
Accountancy Disciplines VIII Technical Standards In determining whether a measure is in conformity
with the obligations [that a measure be not more trade restrictive than necessary to fulfil a legitimate objective], account shall be taken of internationally recognised standards of relevant international organizations applied by that member.
“Internationally recognised” standards, not just international standards
Take account of – again no presumption of conformity
International standards
In sum Relevant to the assessment of whether measure is
more trade restrictive than necessary Would facilitate the operation of a necessity test
Also could facilitate development of more MRAs covering more members
Might facilitate implementation of Article VI.6 requirement to have adequate procedures in place to verify the competence of professionals from any other WTO Member Might make it easier to do this for all WTO members.
International standards
However, there are relatively few international standards in services Probably for same reason as recognition has
proven difficult to achieve Also, need large scale trade to make it
worthwhile – expect to increase in coming years
Questions also arise about the capacity of all WTO Members to participate in standard setting.
Structure of presentation
Introduction Key terms Key legal provisions
Equivalence Article VI.6 (verifying competence) Recognition (GATS Article VII) Guidelines on Mutual Recognition in the Accountancy Sector Accountancy Disciplines MRAs
International standards Article VII.5 Article VI.5 Accountancy Disciplines
Concluding thoughts
Concluding thoughts
MRAs one way to meet the Accountancy Disciplines’ requirement to take account of qualifications already achieved on the basis of equivalence Could contribute to ensuring that measures relating to
qualification requirements are not more trade restrictive than necessary
A necessity test can also be a way of defending the rights of those countries who are currently excluded from MRAs by ensuring that they are not subject to unnecessarily trade restrictive requirements.
Need Article VI.6 general requirement for those countries not covered by MRAs.
Concluding thoughts
The existence of international standards would facilitate implementation of a possible necessity test International standards would also assist in the
development of MRAs Might also facilitate implementation of VI.6
obligation to have adequate procedures to verify the competence of professionals from any other WTO Member.
Development of international standards could clearly have a trade facilitating effect.
Concluding thoughts
However, both MRAs and international standards have proven difficult and slow to develop.
The difficulties encountered in determining whether different measures met the same regulatory objective suggest that it might also be difficult to make such determinations in the context of a necessity test. Development of Article VI.4 disciplines and MRAs or
international standards are slow for similar reasons.
Thank you