surveying course sample problems

Upload: brianrivera

Post on 11-Oct-2015

45 views

Category:

Documents


7 download

DESCRIPTION

survyeing sample problems you can use for the professional engineering license in the state of california

TRANSCRIPT

  • 5/21/2018 Surveying Course Sample Problems

    1/16

  • 5/21/2018 Surveying Course Sample Problems

    2/16

  • 5/21/2018 Surveying Course Sample Problems

    3/16

  • 5/21/2018 Surveying Course Sample Problems

    4/16

  • 5/21/2018 Surveying Course Sample Problems

    5/16

  • 5/21/2018 Surveying Course Sample Problems

    6/16

  • 5/21/2018 Surveying Course Sample Problems

    7/16

  • 5/21/2018 Surveying Course Sample Problems

    8/16

    SURVEYING REVIEW COURSE

    Review Problems #3

    Problem #1:

    Intermediate points that are set during a level run to transfer elevations between

    benchmarks are called:

    (A)benchmarks

    (B)backsights

    (C)turning points(D)intermediate foresights

    Problem #2:

    A leveling rod is held on a point whose elevation is to be determined. The distance to therod is 153 ft, and the FS reading is 5.30. What is the elevation of the point if the HI is

    530.00 ft?

    (A)524.70 ft

    (B)535.30 ft(C)677.70 ft

    (D)688.30 ft

    Problem #3:

    Benchmarks established as a basis of control for lower-order work are usually establishedusing what procedure?

    (A)precise leveling(B)spirit leveling

    (C)trigonometric leveling

    (D)differential leveling

    Problem #4:

    Given the following leveling circuit notes, what is the adjusted elevation of the temporary

    benchmark (TBM 1)?

  • 5/21/2018 Surveying Course Sample Problems

    9/16

    Problem #5:

    What is the purpose of a turning point in a bench circuit?

    (A)It serves as a point of known elevation immediately after the instrument has been

    repositioned.(B)It serves as the point about which the error of closure is distributed.

    (C)

    It serves as a temporary benchmark (TBM).(D)It serves as the point upon which an instrument is to be repositioned.

    Problem #6:

    What type of survey control does a benchmark provide?

    (A)horizontal control only(B)vertical control only

    (C)as designated on the recorded map

    (D)both (A) and (B)

  • 5/21/2018 Surveying Course Sample Problems

    10/16

    Problem #7:

    For the traverse shown, evaluate the length and bearing of missing side DA.

  • 5/21/2018 Surveying Course Sample Problems

    11/16

  • 5/21/2018 Surveying Course Sample Problems

    12/16

  • 5/21/2018 Surveying Course Sample Problems

    13/16

  • 5/21/2018 Surveying Course Sample Problems

    14/16

  • 5/21/2018 Surveying Course Sample Problems

    15/16

  • 5/21/2018 Surveying Course Sample Problems

    16/16