t70 jaguar transmitter instruction - tele … antenna or the ... switch channel. t70 jaguar...

2
TROUBLE SHOOTING What is your problem What might have caused it What to do The receiver does not react when the trans- mitter buttons are pressed. No transmitter has been registered in the receiver. Register the transmitter in the receiver. The transmitter does not start when the start buttons are pressed at the same time for approx. 1 sec. and then released. The battery has been discharged. Charge the battery. The hardware may be broken. Contact your representative. The range is too short. The antenna or the antenna cables are damaged or incorrectly installed. 1. Change the position of the antenna. 2. Replace the antenna cable. Someone else may be transmitting on the same channel. Switch channel. T70 JAGUAR TRANSMITTER INSTRUCTION 1 4 5 7 8 6 2 3 1 4 2 3 1. Push button 1 2. Push button 2 3. Push button 3 4. Push button 4 5. Push button 5 6. Push button 6 7. Push button 7 8. Push button 8 TECHNICAL DATA DEGREE OF PROTECTION: IP65 OPERATING FREQUENCY: 433 MHz. CHANNEL: 64 CHANNEL SEPARATION: 25 kHz. SIZE: 66 x 113 x 35 mm./ 2.6 x 0.4 x 0.1 in. WEIGHT: Approx. 120 g./ 0.3 lbs. CODE COMBINATIONS: 16.777.216 IM-T70-TX005-A01 © Tele Radio AB IMPORTANT! Tele Radio remote controls are often built into wider applications. We recommend that the system is provided with a wired emergency stop where necessary. TX1-C: 06TTB, 12TTB TX1-A/ TX1-B: 02TTB, 03STB T70-TX06TTB, T70-TX12TTB, T70-TX02TTB, T70-TX03STB NOTE! THE COMPLETE INSTALLATION INSTRUCTIONS CAN BE DOWNLOADED FROM OUR WEB SITE. 1. Press the ON button for at least 1 second until the LED lights red. 1. Press the OFF button. 1. The transmitter will turn off when no buttons have been pressed for 180 seconds. START THE TRANSMITTER TURN THE TRANSMITTER OFF AUTOMATIC SHUT OFF REGISTER THE TRANSMITTER Depending on receiver model, you can register 1-3 trans- mitters. NOTE! If several transmitters are used with one receiver, they must all use the same frequency bank. See the complete instruction for more detailed descriptions. 1. Start the transmitter. 2. Press transmitter buttons 1+2 at the same time. Keep pressed until all steps have been performed. F S F S 3. Press the receiver FUNCTION button until the red code storing LED on the receiver lits up. 4. Press the receiver SELECT button until all red relay LEDs lit up. The receiver starts to search for and connect to the transmitter. When the transmitter has been stored, the red relay LEDs on the receiver flash 3 times. 5. Release all transmitter buttons. 1 4 2 3 1 4 5 7 8 6 2 3 ON OFF

Upload: dinhnga

Post on 20-May-2018

223 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: T70 JAGUAR TRANSMITTER INSTRUCTION - tele … antenna or the ... Switch channel. T70 JAGUAR TRANSMITTER INSTRUCTION 1 4 5 7 8 6 1 2 3 4 2 3 1. Push button 1 2. ... 7 433.675 8 433.775

TROUBLE SHOOTINGWhat is your problem What might have

caused itWhat to do

The receiver does not react when the trans- mitter buttons are pressed.

No transmitter has been registered in the receiver.

Register the transmitter in the receiver.

The transmitter does not start when the start buttons are pressed at the same time for approx. 1 sec. and then released.

The battery has been discharged.

Charge the battery.

The hardware may be broken.

Contact your representative.

The range is too short. The antenna or the antenna cables are damaged or incorrectly installed.

1. Change the position of the antenna.2. Replace the antenna cable.

Someone else may be transmitting on the same channel.

Switch channel.

T70 JAGUAR TRANSMITTER INSTRUCTION

14 57 8

62 31

42 3

1. Push button 12. Push button 23. Push button 34. Push button 4 5. Push button 56. Push button 67. Push button 78. Push button 8

TECHNICAL DATA

DEGREE OF PROTECTION: IP65OPERATING FREQUENCY: 433 MHz.CHANNEL: 64 CHANNEL SEPARATION: 25 kHz.SIZE: 66 x 113 x 35 mm./ 2.6 x 0.4 x 0.1 in.WEIGHT: Approx. 120 g./ 0.3 lbs.CODE COMBINATIONS: 16.777.216

IM-T70-TX005-A01 © Tele Radio AB

IMPORTANT! Tele Radio remote controls are often built into wider applications. We recommend that the system is provided with a wired emergency stop where necessary.

TX1-C: 06TTB, 12TTBTX1-A/ TX1-B: 02TTB, 03STB

T70-TX06TTB, T70-TX12TTB, T70-TX02TTB, T70-TX03STB

NOTE! THE COMPLETE INSTALLATION INSTRUCTIONS CAN BE DOWNLOADED FROM OUR WEB SITE.

1. Press the ON button for at least 1 second until the LED lights red.

1. Press the OFF button.

1. The transmitter will turn off when no buttons have been pressed for 180 seconds.

START THE TRANSMITTER

TURN THE TRANSMITTER OFF

AUTOMATIC SHUT OFF

REGISTER THE TRANSMITTER

Depending on receiver model, you can register 1-3 trans-mitters. NOTE! If several transmitters are used with one receiver, they must all use the same frequency bank. See the complete instruction for more detailed descriptions.

1. Start the transmitter.

2. Press transmitter buttons 1+2 at the same time. Keep pressed until all steps have been performed.

F S

F S

3. Press the receiver FUNCTION button until the red code storing LED on the receiver lits up.

4. Press the receiver SELECT button until all red relay LEDs lit up.The receiver starts to search for and connect to the transmitter. When the transmitter has been stored, the red relay LEDs on the receiver flash 3 times.

5. Release all transmitter buttons.

142 3

14 57 8

62 3

ON

OFF

Page 2: T70 JAGUAR TRANSMITTER INSTRUCTION - tele … antenna or the ... Switch channel. T70 JAGUAR TRANSMITTER INSTRUCTION 1 4 5 7 8 6 1 2 3 4 2 3 1. Push button 1 2. ... 7 433.675 8 433.775

BATTERY PRECAUTIONS

Observe the following warnings.

• Asbatteriescontainsflammablesubstances such as lithium or other organic solvents, they may cause

• heating, rupture or ignition.• Risk of explosion if battery is replaced

with a battery of an incorrect type. • Do not short circuit, disassemble,

deform or heat batteries. • Never try to charge a visibly damaged

or frozen battery.• Do not charge rechargeable batteries with a higher voltage than specified.

• Keep batteries out of reach of small children. Should a child • swallow a battery, consult a physician immediately.• Avoid direct soldering to batteries.• When discarding batteries, insulate the + and - terminals of • batteries with insulating/ masking tape. Do not put multiple • batteries in the same plastic bag.• When improperly disposed, lithium batteries may short circuit,

causing them to become hot, burst or ignite.• Store in a cool location. Keep batteries away from direct sun-

light, high temperature, and high humidity. • Donotthrowbatteriesintofire.

ROHS AND WEEE

In accordance with Directive 2002/95/EC on restriction of the use of certain hazardous substances in electrical and electronic equip-ment (RoHS) and Directive 2002/96/EC on waste electrical and electronic equipment (WEEE), Tele Radio strives to minimize the use of hazardous materials, promotes reuse and recycling, and reduces emissions to air, soil and water. When a commercially viable alternative is available, Tele Radio strives to restrict or eliminate substances and materials that pose an environ-mental, health or safety risk.

DISPOSAL OF BATTERIES AND ELECTRONICS

An alkaline battery does not contain mercury, cadmium or lead, and is better for the environment than older types of batteries. Alkaline batteries should be disposed through local recycling stations/waste dumps. Contact your local government’s recycling or solid waste department for more information on proper recycling of alkaline batteries in your region. Improperly disposed batteries and elec-tronics may harm public health and the environment. Batteries and electronic waste may contain toxic heavy metals. If thrown away in the trash, the toxic compounds can leach into soil and water, pollute lakesandstreams,makingthemunfitfordrinking,swimming,fishing,and wildlife. Contact your local government’s recycling or solid waste department for more information on proper disposal of batteries and electronics in your region.

IM-T70-TX005-A01 © Tele Radio AB

1. Remove the clip (2 screws).

2. Remove the battery lid (2 screws).

3. Put the batteries in

(3 x 1.5V AA batteries).

For optimum performance use alkaline batteries.

1. Start the transmitter.

2. Press the OFF button. Keep pressed.

3. Press the ON button. Keep both buttons presseduntiltheLEDstartstoflash.

4. Release both buttons.

5. Press button 1 to move 1 step down.

6. Press button 3 to move 1 step up

INSTALL/ CHANGE BATTERIES

FREQUENCY TABLE

SWITCH CHANNEL

TELE RADIO SVERIGESwedenTel. +46 (0)31-724 98 00e-mail: [email protected]

TELE RADIO GmbHGermanyTel. +49 (0)94 51-944 8 550e-mail: [email protected]

TELE RADIO ASIAChinaTel. +86-(0)592-3111168e-mail: [email protected]

TELE RADIO TURKEYTurkeyTel. +90 216 574 22 94e-mail: [email protected]

TELE RADIO LTDEnglandTel. +44 (0) 1625 509125e-mail: [email protected]

TELE RADIO LLCNorth America & Latin AmericaTel. +1 (305) 459 0763e-mail: [email protected]

TELE RADIO BVBeneluxTel. +31-(0)70-419 41 20e-mail: [email protected]

TELE RADIO ASNorwayTel. +47-6933 4900e-mail: [email protected]

TELE RADIO ABSweden, Main officeTel. +46 (0)31-748 54 60e-mail: [email protected]

www.tele-radio.com

!

CHANNEL FREQ.BANK 1

1 433.075

2 433.175

3 433.275

4 433.375

5 433.475

6 433.575

7 433.675

8 433.775

9 433.875

10 433.975

11 434.075

12 434.175

13 434.275

14 434.375

15 434.475

16 434.575

CHANNEL FREQ.BANK 2

1 433.100

2 433.200

3 433.300

4 433.400

5 433.500

6 433.600

7 433.700

8 433.800

9 433.900

10 434.000

11 434.100

12 434.200

13 434.300

14 434.400

15 434.500

16 434.600

CHANNEL FREQ.BANK 4

1 433.250

2 433.350

3 433.450

4 433.550

5 433.650

6 433.750

7 433.850

8 433.950

9 434.050

10 434.050

11 434.150

12 434.250

13 434.350

14 434.450

15 434.550

16 434.650

CHANNEL FREQ.BANK 3

1 433.125

2 433.225

3 433.325

4 433.425

5 433.525

6 433.625

7 433.725

8 433.825

9 433.925

10 434.025

11 434.125

12 434.225

13 434.325

14 434.425

15 434.525

16 434.625

OFF

ON

142 3

142 3