tamlyn color flashing
TRANSCRIPT
ColorPlus™Technology
JamesHardieRecommended by
TM
© 2009 R.H. Tamlyn & Sons, LP 800.334.1676 www.colorplusflashing.com
ColorPlus Technology logo, Recommended logo, HardiePanel and HardiePlank are trademarks or registeredtrademarks of James Hardie International Finance B.V.
Plank FlashLap Siding Joint Flashing
PRODUCT DETAIL
DESIGN FEATURES
Use to prevent moisture from penetrating behind the joint where two planks butt together. Pre-cut for quick and easy installation. Conveniently clips to your belt.
The recommended method for butting factory-finish ends for all HardiePlank® lap siding is moderate contact over a piece of joint flashing. This method is required for joining ColorPlus® lap siding products.
Flashing behind butt joints provides an extra level of protection against the entry of water at the joint. James Hardie recommends 6" wide flashing that overlaps the course below by 1". Some local building codes may require different size flashing.
James Hardie does not recommend the use of caulk at field butt joints.
MATERIAL
3105-type aluminum sheet coated on both sides with Dymalar® 2000 paint system that is specifically formulated for residential exterior applications.
Standard colors shown below. Other colors available upon request.
INSTALLATION DETAIL
Stud WallSheathing
Water ResistiveBarrier
HardiePlank™Siding
Plank Flash
6"
Length
1/4"
Arctic White
NavajoBeige
KhakiBrown
CobbleStone
SailCloth
MontereryTaupe
BlackWoodland
CreamWoodstock
BrownAutumn
TanLightMist
SandstoneBeige
Tamlyn Color FlashingTamlyn Color Flashing