CCIE SP Written

Exam, V3.0

350-029

350-029

QUESTION NO: 333

What is the purpose of Dual Ring Interconnect with D C for SDH rings?

A. Protects signals when a ring switch fails

B. Protects signals when multiple span switches fail

C. Protects pre-emptible traffic from being dropped when a ring switch occurs

D. Protects signals against any combination of link failure in each ring

Answer: D

350-029

QUESTION NO: 334

MPLS label mapping on an LSR is displayed by which IOS command?

A. Show mpls Idp neighbor detail

B. Show mpls Idp bindings

C. Show mpls Idp parameters

D. Show mpls Idp discovery

Answer: B

350-029

350-029

QUESTION NO: 335

In a cable HFC plant, what is a modulator?

A. Set top box

B. Diplex filter

C. Local head end

D. Fiber node

Answer: A

350-029

QUESTION NO: 336

What is the main difference between the information displayed on the dspload and the dsptrkutl screens?

A. The dspload screen is for all trunks; the dsptrkutl screen is for

one trunk. B. The dspload screen shows the expected traffic; the dsptrkutl

screen shows actual traffice. C. The information on the dspload screen never changes; the

dsptrkutl screen is dynamic D. The dspload screen shows historical information; the dsptrkutl

screen shows current information.

Answer: B

350-029

QUESTION NO: 337

An architecture that utilizes PPPoE deals with IP address allocation by what type of negotiation?

A. NIS B. IPCP C. RADIUS D. LDAP

Answer: B

350-029

350-029

QUESTION NO: 338 Which of the following is true regarding Label

Distribution Protocol (LDP)? A. It is a label distribution protocol for MPLS. B. It is a set of procedures and messages by which

LSRs establish Label Switch Paths (LSPs) through a network

C. Tag distribution Protocol (TDP) was the basis for LDP.

D. All of the above are true.

Answer: D

350-029

QUESTION NO: 339

GMPLS is based upon Non-Packet-based devices

A. True

B. False

Answer: A

350-029

350-029

QUESTION NO: 340

What does FRTP stand for?

A. Frame Relay Top Pseudowire

B. Frame Relay Traffic Pseudowire

C. Frame Relay Traffic Protocol

D. Frame Relay Traffic Policing

Answer: D

350-029

350-029

QUESTION NO: 341 In MPLS traffic engineering, which one of the following

protocols is used for Path Setup?

A. BGP B. OSPF C. ISIS D. RSVP

Answer: D

350-029

QUESTION NO: 342

For SONET ring switching, the 50ms switch time: Select

all that apply

A. Plncludes the detection time

B. Applies to rings smaller than 1200km

C. Applies to rings smaller than 1000km

D. Includes up to 16 nodes

Answer: B,D

350-029

350-029

350-029

350-029

For Complete real exam in just $39 go on http://www.testbells.com/350-029.html

350-029