This is

NUUONUUOIO DeviceIO Device

Install IO Device

IO Card

Capture Card

IO BoxConverter

USB RS485 RS485

RS485PCI

PCI

MPEG-4 Series

H.264 Series

• Open Main Console > Config > Setting > I/O Device1. Module Setting• Enter Module name of device• Choose Device model

– Refer IO Box or IO Card

• Set COM Port of device– My computer > manage > Computer management

> Device Manage > Ports (COM & LTP)

– It’s will show Prolific USB-to-Serial Comm Port (COM3)

• Set ID of device– Right Check on Device and choose properties >

Port Setting > Check Bits per second (Baud Rate)

It will get Baud rate

– Use Tool “IOConfig.exe” to get ID information

– Input COM port, Baud rate, and set Starting address from “0”.

– And click “scan” to search.

– The Address “0” will show as below

Right Click

2. I/O Device List• Show device already installed in system• Choose device

3. Device Setting• Modify name• Set I/O state

– N/C : normal Close

– N/O : normal Open

4. Digital input Monitor• It will become red when

signal input

5. Digital output simulation• Click to send output signal• It will become red