three wide locker assembly - static.globalindustrial.com
TRANSCRIPT
DOUBLE TIER ASSEMBLY 6-TIER ASSEMBLY
BOTTOM
SIDE
SHELF
TOP
4. Repeat step 3 until bankof lockers is complete.Bolt on side
globalindustrial.com
Three Wide Locker Assembly
AssemblyInstructions
Customer Service1-800-645-2986
Page 1
Please read the complete instructions.
Check for missing or damaged parts.
Only use the specified hardware. Alwaysuse a #1 Bolt with bolt head out unlessotherwise specified.
CAUTION: Some parts have sharp edgesand corners, wear gloves during assembly.
Assembly will require the following tools:• 2 drift pins (or 2 nail punches) for hole
alignment• 3/8" socket wrench
Lockers should be assembled on a flat, levelsurface and anchored according to theinstructions found in Section 7 & 9.
Locker Assembly
Before Assembly
1. Bolt together top and bottom with bendsfacing down and the back with the bendsfacing up. Top and bottom are identical.For single and double-tier models, bolthook to back.
2. Bolt on side with bend in rear and facing in. Omit 2 bolts near bottom rearfor legs. Install shelf by bolting to side with bend facing down and 45°bend in front. (See Section 8 Punching Patterns for single, double and 6-tier shelf hole locations.)
3. Bolt together tops, bottoms,shelves, and backs with a sidein between.
BACKBOTTOM
TOP
SIDE
BOTTOMTOP
SHELF
BACK
DOUBLE TIER ASSEMBLY 6-TIER ASSEMBLY
SINGLE TIERASSEMBLY
DOUBLE TIER ASSEMBLY 6-TIER ASSEMBLY
BOTTOM
SIDE
SHELF
TOP
BACK
6-Tier Double-Tier Single-Tier
Page 2Three Wide Locker Assembly Instructions Customer Service 1-800-645-2986
• 18" deep, single-tier lockers includeboth a coat rod and back and sidehooks
• 12” and 15" deep single anddouble-tier lockers include back,side and top double prong hooks
• Six-tier models do not include coatrods or hooks
5. Bolt on hooks and/or coat rod
6. Insert rear legs in each end of locker. Bolt each leg in two places. Rear legs must be amaximum of 36” apart. Attach additional legs as required.
Attach Door Frame Assembly. Leavetop, center and bottom bolts outif attaching to additional lockers.
Slide Leg through bottom
7. Bolt locker foot to leg. Standlocker in place. Level them andadjust rear legs to touch floorand tighten bolts. Floor anchornot included. Bolt banks oflockers together using holesomitted in step #5.
Anchor individual lockers usinglocker foot on all four legs.For banksof lockers, anchor extreme ends plusintermediate lockers on 36” centers maximum.
Leg
Locker Foot
Coat Rod
Double Prong Hook Bolts toBottom Of Top or Shelf
Side Hook & Back Hook
WARNING:–FLOOR ANCHOR MUST HAVE A MINIMUM
PULL-OUT VALUE OF 190 LBS.–WALL ANCHOR MUST HAVE A MINIMUM
PULL-OUT VALUE OF 150 LBS.
8. Punching Patterns
60” Sides & Backs 72” Sides & BacksS.T. = Single Tier
D.T. = Double Tier
Bolthere
Page 3
9. Recommended Anchoring Methods
Three Wide Locker Assembly Instructions Customer Service 1-800-645-2986
((EEAACCHH RROOWW))