time: 03 hours' maximum marks: 100 4 instruction to ...librarian/question papers/m.tech...
TRANSCRIPT
f
I'O.UJrI "IIu; ".".."""."""""'. ~Total No. of Questions: 08] [Total No. of P~ges : 02
~~
"-. Paper ID [PESOS](Please fill this Paper ID in OMR Sheet) . I MAY 2[)D~
. . stM.Tech. (Sem. - 1 )
COMPUTER AIDED DESIGN AND MANUFACTURING (PE - 505)
Time: 03 Hours' Maximum Marks: 1004
. +4~K. . ;p... #liAr, (/4i
Instruction to Candidates:
1) Attempt any Five questions. MAy 2008 ,"
2) All questions carry.equal marks.
Ql) With the help of mathematical model, explain the difference between CAD/CAM and Automation. . .
Q2) (a) What is the importance of standards in CAD/CAM? .(b) How Initial Graphics Exchange .Specification (IGES) is differing from
Graphical Kernel System.(G~S)?
Q3) (a) Compare 2-dimensional and 3-dimensional wire frame models.
(b) Describe the importance of curve and surface modeling in computeraided graphics and design.
Q4) Describe brieflythe followingmethods of surfacemodelingwith two applicationexamples:
(a) Revsurf
(b) Tabcyl
Q5) What is mea~t by sweep? Discuss in detail the various types of sweeptechniques available for 3D geometric construction. .
Q6) A scaling factor of 2 is applied inYdirection and while no scaling is applied inX direction to the line whos~ end points are at coordinates (1, 3) and (3, 6).The line is to be rotated subsequently through 30° in the counter clockwisedirection. Determine the necessary transformation matrix for the operationand the new coordinates of the end points.
R-1188 [2058J RT.O.
rQ7} Differentiate between nl!illeric control (NC), computer numerical control (CNC)
and direct numerical control (DNC) systems of CAM. .
Q8} Write short note on any two of the following:,.
(a1: Fixed a~d floating zero
(b) Assembly and Tolerancing"-
(c) Operating system
.."
DODD
"e ." "
.J:"
----.
L
""
fQ7) Differentiate between nl!l1lericcontrol (NC), computer numerical control (CNC)
and direct numerical control (DNC) systems of CAM. ..
Q8) Write short note on any two of the following:, ,
(a,"' Fixed a~d floating zero
(b) Assembly and Tolerancing
(c) Operating system
,,",
DODD
,.,;, ~
-........ L
"<