toyota recall - denso vs. cts - cts acceleration module series 576
DESCRIPTION
CTS Module This is the acceleration module from a Toyota vehicle equipped with a CTS gas pedal, this is one of the components that is utilized in sending a voltage signal to the cars computer to determine pedal position.TRANSCRIPT
Industrial33mm SizeConductive PlasticPrecision Rotary SensorFeatures
• Robust Construction
Series 576
1 - 2 © 2009 CTS Corporation. All rights reserved. Information subject to change. 10/19/09
CTS Electrocomponents www.ctscorp.com
Data SheetData SheetAcceleration Module®
Electrocomponents
• Precision Center Voltage
• Center Return Mechanism
• 2 Million Life Cycles• Flexible Mechanical Installation
• Water Resistance (IP64)
Electrical and Mechanical Specifications
Resistance Range5 K ohms, linear
Resistance Tolerance± 10%, ± 20%
Power Rating0.2 watts @ 40°C
Maximum Operating Voltage
16 VDC
Rotational Angle Mechanical angle: 40°Effective angle: 40°
Rotational Torque1.4 ± 0.2 kgf-cm minimum
Stop Strength20 kgf-cm minimum
Mounting Information4-Ear Mounting
Insulation Resistance1000 Megohms minimum @ 500 VDC
Dielectrical Strength500 VDC for 1 minute
Push-Pull Strength of Shaft12.7 kg for 10 seconds
Rotational life2 Million life cycles
TemperatureOperating: -10°C ~ 85°CStorage: -40°C ~ 125°C
Solder Heat Resistance350°C for 5 seconds
Linearity± 2%
• 2% Precision Linearity• RoHS Compliant
Shaft Wobble± 0.2 X ( L / 21.8) mm maximum
Shaft InformationLever with 2 mounting points
(L is length from mounting surface)
Water ResistanceIP64
Ordering Information
576T Metal Shaft, 4-Ear Mounting, Metal Lever, Solder Lug Terminal
2 - 2 10/19/09CTS Electrocomponents www.ctscorp.com
Notes:Standard Part - 576T502A2APlease consult factory for custom or not listed features.
© 2009 CTS Corporation. All rights reserved. Information subject to change.
A - ± 10%B - ± 20%
RESIST TOL
RESISTANCE CODE
A
TERMINAL STYLE
T - SOLDER LUG
CODE RESISTANCE502 5 K
LINEARITY
576 T 502 A 2
2 - ± 2%
ROTATIONAL ANGLE Mechanical EffectiveA - 40° 40°
DIMENSION : mmSTANDARD TOLERANCE : .X (1 PLACE) : ±0.3 .XX (2 PLACE) : ±0.13
4.9 (3)
3.0 (3)
10.0CENT.
M4 X 0.7 THD. (2)
Ø6.0 C'BORE3.0 DP. (4)
R5.5 (4)
11.5 (4)
THRU.HOLE Ø3.0 (4)
33.0
6.512.0
20.0
30.0
33.0
45
40
° TYP.
40°ANGLE OF ROTATION (MECH.)
0.4
8.4
°(4)
R7.5
Ø20.0
4.8
23.0
INPUT5K Ohm ± 10%
A
GND
B
OUTPUT
C
0.5
14.1
21.8
16.011.0
13.0
6.0
9.3
A B C
10.0