transverse wave
DESCRIPTION
Transverse Wave. The direction of particle oscillation is perpendicular to the direction of wave propagation. http://www.cbu.edu/~jvarrian/applets/waves1/lontra_g.htm. Longitudinal Wave. Compression. Rarefaction. - PowerPoint PPT PresentationTRANSCRIPT
Transverse Wave
The direction of particle oscillation is perpendicular to the direction of wave propagation.
http://www.cbu.edu/~jvarrian/applets/waves1/lontra_g.htm
Longitudinal Wave
RarefactionCompression
The direction of particle oscillation is parallel to the direction of wave propagation.
http://www.cbu.edu/~jvarrian/applets/waves1/lontra_g.htm
Speed of Propagation
f
Tv
t
dv
Determined by the medium.
Determined by the source.
Example Problem 1
A) What is the wavelength?
B) What is the amplitude?
It takes 5 [s] for the piece of wave shown to pass a given point.
C) What is the period?
D) What is the speed of the wave?
Intensity and Decibels
area
power
time area
energyintensity
Intensity is measured in watts per square meter.
Intensity follows an inverse square law.
The range of intensities that the human ear can detect is too large to deal with linearly, so a logarithmic scale is used. This scale is known as the decibel scale.
0
log10level decibelI
I
Source IntensityIntensity
Level# of Times
Greater Than TOH
Threshold of Hearing (TOH) 1*10-12 W/m2 0 dB 100
Rustling Leaves 1*10-11 W/m2 10 dB 101
Whisper 1*10-10 W/m2 20 dB 102
Normal Conversation 1*10-6 W/m2 60 dB 106
Busy Street Traffic 1*10-5 W/m2 70 dB 107
Vacuum Cleaner 1*10-4 W/m2 80 dB 108
Large Orchestra 6.3*10-3 W/m2 98 dB 109.8
Walkman at Maximum Level 1*10-2 W/m2 100 dB 1010
Front Rows of Rock Concert 1*10-1 W/m2 110 dB 1011
Threshold of Pain 1*101 W/m2 130 dB 1013
Military Jet Takeoff 1*102 W/m2 140 dB 1014
Instant Perforation of Eardrum 1*104 W/m2 160 dB 1016
Audible Range
• In addition to the range of sound intensities that are detectable by the human ear, there is also a range of frequencies.
• Human beings can typically detect frequencies between 20 [Hz] and 20,000 [Hz]. This is known as the audible range.
• The frequencies that are detectable by the human ear change with age. For example, younger people are able to detect higher frequencies than older people.
Example Problem 2
• A point 2 [m] from a speaker experiences a sound intensity level of 100 [dB]. What is the sound intensity level at a point 5 [m] from the speaker?
Boundary Behavior
• Three things occur when a wave is incident on the boundary between two media:– Part of the wave is reflected (it stays in the
original medium)– Part of the wave is transmitted (it passes
through to the new medium)– Part of the wave is absorbed (some of the
energy is converted to internal energy of particles at the boundary)
Conservation of Energy (yet again)
absorbeddtransmittereflectedincident EEEE
ReflectionLow density to high density
High density to low density
The pulse is inverted.
This corresponds to a phase shift of π radians.
The pulse is not inverted.
This corresponds to a phase shift of 0 radians.
“Low to high, pi. High to low, no.”
The angle of incidence is equal to the angle of reflection.
Refraction
When a wave travels from one medium to another, it experiences a change in speed.
This change in speed results in a change in direction. This is known as refraction.
Doppler EffectThe source is stationary.
The wavefronts have the same spacing for both observer A and observer B.
Both observer A and observer B detect the same frequency, which is the actual frequency being produced.
The source is moving at a speed less than the speed of the wave.
The wavefronts appear closer together to observer B than they do to observer A.
Observer B detects a higher apparent frequency.
Observer A detects a lower apparent frequency.
The source is moving at a speed equal to the speed of the wave.
The wavefronts stack up on one another in the direction that the source is traveling.
For sound, this buildup of pressure is known as the “sound barrier”.
The source is moving at a speed faster than the speed of the wave.
The source is outrunning the wavefronts it produces.
The cone shaped area of very high pressure is known as a “shock”.