trib9602-0396
DESCRIPTION
EATONTRANSCRIPT
-
Eaton Truck Components BulletinEaton CorporationTruck Components Operations North AmericaP.O. Box 4013Kalamazoo, MI 49003
This bulletin contains product improvement information.Eaton Corporation is not committed or liable for canvassing existing product.
Bulletin Type: Service Procedures Parts Information Warranty Info.
Product Line: Axle Brake Clutch
Transmission AfterMarket Speciality
Topic:
TRIB-9602
Fastener Change For Remote ControlHousings. Model LRC-3 and LRC-4and All SRCs(Excludes LRC-1 & LRC-2)
3/96
4
4
4
As of June 1, 1995, Eaton Corporation has revised the size of the mounting holes on all remote control housings (see illustra-tion below). The new design increased the diameter and removed the chamfer on the mounting holes of the remote housing.
Capscrews replace the studs and nuts that once held the remote control to the transmission shift bar housing. To mount theremote control you must use the proper fastener for that design level. If the old design level remote control is ordered, the newdesign level remote control will be substituted in its place.
Old Part Number Replaced By 20890 K-3111 20889 K-3110 16379 K-3109 16378 K-3108 16377 K-3107 16376 K-3106 16375 K-3105
Tighten all fasteners to 35 - 45 lbs. ft.
Mounting Hole Size RevisedFor These Four Holes
CURRENT
X-8C-604Bolt & Washer Assy.
11932 Washer
OBSOLETE
X-8-680 Bolt
14249 Stud
OBSOLETE
X-1-610 Nut
NOTES:
1) New Fastener Part # X-8C-604
2) RTO 2 series transmissions (example: RTO16210) use the metric flange head fastener part # X-8-1005M