turbo finish case study - gear deburring, edge-contour
TRANSCRIPT
Turbo-Finish Case StudyTurbo-Abrasive Machining (TAM) Applications
Dr. Michael Massarsky | TURBOFINISH CORPORATION | [email protected] | (m) 917.518.8205Dave Davidson | SME MMR Tech Community Advisor | [email protected] | http://dryfinish.wordpress.com
TURBO-FINISH PART OPERATIONS Gear Deburring; Edge-ContourTurbo-Finish is capable of running both rotating and large volumes of smaller non-rotating parts in dry spindle finish applications such as this one
(1) Dry operation. Turbo-Finish produces both smoothing and polished surface effects with an entirely dry operation. No wet waste is generated.(2) Horizontal Spindle Operation. Unlike other spindle methods, the Turbo-Finish method utilizes horizontal spindles, accommodating several parts or part fixtures on the same spindle or on multiple processing spindles(3) Rapid edge and surface finish development. Unlike other spindle-finish methods, spindle rotating speeds in the hundreds and even thousands rpm are possible because of Turbo-Finish’s unique media delivery system.
BEFORE
AFTER