MANUAL

TV Wall Mount with Two ShelvesHardware List

Parts List

Three positions allow you to select the best height for your TV set on the stand. Use the appropriate hooked opening on the vertical bar (11) to determine TV height. Using the top hooked opening on vertical bar (11) will set the TV lower on the stand, while the bottom hooked opening will set the TV higher on the stand. Attach one of the three hooked opening to the upper cross bar of the TV stand.

Select Height for Your TV Set

A B

11

C

A) With two people, carefully life the top of the TV to hang the vertical rails (part # 7) onto the horizontal cross bar of the TV mount, catching the hooked opening of the vertical rails securely. Next, secure the bottom of the vertical rails and �rmly 'lock' them into place. (Refer to step 6 to determine appropriate height setting).

B) Using a screwdriver and the two fasteners labeled part "K", thread (each) fastener upwards through the angled metal tab on Side A and Side B to secure both vertical rails onto the TV bracket. Note: Since your TV is now wall mounted, access to these fasteners will be limited. If your TV is facing you, please swivel the TV to the left to tighten the fastener on 'Side A' and then swivel to the right to tighten the fastener on 'Side B'.

Side A

Side B

Attach Rails to TV Bracket

Installation InstructionsA) Assemble TV bracket via diagram (a) below .B) Assemble threaded rod assembly. Screw C

Attach TV Bracket to shelf assembly.RUN Wires.

A) Stand up assembly 3 vertically.

B) Attach TV bracket from step 1 onto the two brackets shown in �gure (4) Tighten In two places with bolt (G) and nut (I) .

C) Pre run wires for components to desired location through holes in back of shelf. Neatly bundle wires behind recessed channel in shelf. 

Hang TV shelf Assembly Onto Wall Bracket. 

A) Pick up TV Shelf Assembly and hang onto wall bracket from step 2.

B) Tighten two screws B into wall bracket with wrench K . 

Note, that the top of this bracket will represent the top

Concrete/Brick Installation:Align bracket in desired locationon the wall, then level top of bracket. Transfer 4 marks onto wall via pencil or marker. Drill (4) 7/16 inch holes and install concrete anchor F into the wall. Anchor should be �ush with outside wall.

Wood Stud Installation:Find the preferred vertical position of wall bracket. Find center of stud with stud �nder. Align three holes in center of wall bracket

Use screw E and washer D to tighten bracket into wall.

with center of stud, put level on top of bracket and make sure it is level. Mark three holes in said location. Pre drill 5/16 pilot hole and tighten bracket into stud with screws E.

NOTE: MAKE SURE TO FIND CENTER OF STUD FOR INCREASED STRENGTH.

Note, two people maybe required to hold parts in place while tightening assembly. Lay parts �at on �oor. 

A) Align parts on the �oor per diagram (3).  Insert two threaded rods from Step 1 into and through parts shown in the diagram (3). 

B) Tighten four screws (a) until assembly is tight with wrench K .  Once tightened properly the shelves should not be able to be moved within the assembly. 

Assemble TV Shelf Attach TV Bracket Hang TV Shelf Assembly

Attach Rails to Back of TV Set

A) Carefully angle your TV against the wall with back of tv shown.   Align two vertical rails in center of your TV.  Use appropriate screw for your TV per chart shown below.

B) Tighten screws until rails are tight.  Do not over tighten . Use spacer if your holes are recessed.  

Note:  Make sure rails are in same holes on both rails to insure TV is level.