unit5&6 cw pump assembly
TRANSCRIPT
-
7/27/2019 Unit5&6 CW Pump Assembly
1/14
CW PUMP ASSEMBLYPROCEDURE
(STEPS TO BE FOLLOWED)
-
7/27/2019 Unit5&6 CW Pump Assembly
2/14
Sub Assemblies of the Pump
Top Shaft Assembly
Intermediate shaft assembly
Bottom Shaft Assembly
-
7/27/2019 Unit5&6 CW Pump Assembly
3/14
Top Shaft Assembly
Top shaft assembly consists of Topshaft with top bearing & gland sleeveand shaft enclosing tube.
Before putting shaft in enclosing tubeinstall shaft locking fixture on the
pump support.
Also install shaft lock on the shaft
-
7/27/2019 Unit5&6 CW Pump Assembly
4/14
Intermediate shaft assembly
Intermediate shaft assembly consistsof intermediate shaft with sleeve andshaft enclosing tube.
Before putting shaft in enclosing tubeinstall shaft locking fixture on the
pump support.
Also install shaft lock on the shaft
-
7/27/2019 Unit5&6 CW Pump Assembly
5/14
Assembly
Use following torque values for the pumpassembly.
Torque Value for Fasteners
S No. Fastener Size(SS316)
Nominal Kg-m
1 M24 37-55
2 M30 77-115
3 M33 100-150
4 M36 130-190
-
7/27/2019 Unit5&6 CW Pump Assembly
6/14
Bottom Shaft Assembly
This is very critical assembly in thepump assembly.
This assembly consists of bowlbearing, casing wear ring, impeller,shaft with sleeve, impeller, locknut/cap nut, cone.
-
7/27/2019 Unit5&6 CW Pump Assembly
7/14
Bottom Shaft Assembly
Take necessary precautions whileinstalling bowl bearing and casing wearring with bowl.
Use RFC Compound on the mating faces of the assembly.
Carry out the proper tightening andensure locking of the fasteners.
-
7/27/2019 Unit5&6 CW Pump Assembly
8/14
Bottom Shaft Assembly
Assemble/install bowl bearing, casing wearring.
Put bottom shaft inside the bowl andprovide necessary support to the shaft sothat enclosing tube can be assembled withthe bowl
Assemble shaft enclosing tube with the bowlflange and use torque wrench for tightening.
-
7/27/2019 Unit5&6 CW Pump Assembly
9/14
-
7/27/2019 Unit5&6 CW Pump Assembly
10/14
Pump Assembly
We have three assemblies with us.
Start lowering the pump assembly frombottom to top assembly.
After lowering of full pump assembly
install gland housing.
-
7/27/2019 Unit5&6 CW Pump Assembly
11/14
Pump Assembly
Thrust bearing assembly. Fill up thelubricating oil for the bearing.
Adjust Pump float.(U5-11mm,U6-6.4mm)
Install pump coupling.
-
7/27/2019 Unit5&6 CW Pump Assembly
12/14
Pump AssemblyMotor pedestal support.
Check coupling gap. (measure and crosscheck pump coupling height withreference from top face of motor pedestalsupport.)
Motor
Alignment (use alignment tool for locatingshaft to the pump centre.)
-
7/27/2019 Unit5&6 CW Pump Assembly
13/14
Pump Assembly
Couple the pump after uncouple runof the motor.
Install gland and air breather valve.
Carry out the pump coupled run andcheck pump vibrations.
-
7/27/2019 Unit5&6 CW Pump Assembly
14/14
TH A N K YO U