UTRASONIC SCALPELSet-up and operation
Model No: ABC-123-45-678
Serial No. 1234-56-879
Throubleshooting
Place generator in a flat and stable surface
Check if the power cord in the back is securely attach.
Set your hand piece and the ultrasonic cable in the mayo table.
Insert the silver end of the blue cable into the bottom opening
of the hand piece.
Holding the silver end of the cable, turn the hand piece clockwise
Until its tight.
Insert the torque wrench on the tip on the hand piece.
Turn the torque wrench clockwise until you hear 2 clicks
Indicating that the hand piece is secure.
Turn on the generator by pressing the power button located
Located in the right lower corner.
Pass off the other end of the cable to be plug in this port
located in the left lower corner.
The circulator will then insert and connect the hand piece
into the generator.
Your circulator can now start test process by pressing test
button in the generator.
You can also perform a test by pressing any of the
button in the hand piece.
You will hear 3 beeps when the test is done,
now the ultrasonic scalpel Is ready to use.
Throubleshooting
• No Power
-Check if power cord is securely attach and the power button is turned on
• Hand piece not working.
- Check cable connecting to the generator
- Make sure hand piece is tightly connected to the cable
- Restart generator by turning it off and on again
- Perform a retest
• Power is not enough or to much.
- Increase or decrease power by pressing the power level button up
and down as needed.
• Generator is to loud or to low
- Turn volume knob down or up located in the left lower corner next to
the power button.
Report Issue
Request for Repair
Ultrasonic Scalpel Generator
Model No: ABC-123-45-678
Serial No. 1234-56-879
Reported Issue: (Choose only one)
No Power
Electrical (e.i. Frayed cable)
Mechanical (e.i. Broken parts)
Other
Choose Room no. 1
2
3
4
5 Send to Bio-med