vertical exterior sensor - sageglass...vertical exterior sensor description sageglass ® is the...
TRANSCRIPT
CUT SHEET: VERTICAL EXTERIOR
SENSOR
The SageGlass® Vertical Exterior Sensor provides ambient light feedback for the SageGlass Controls System. There are two types of Exterior Sensors: Vertical and Horizontal. Vertical sensors are used for automatic glare control only while Horizontal sensors are used for automatic daylight and glare control.
The Vertical sensor provides high-angle ambient light feedback and the Horizontal sensor provides low-angle ambient light feedback. For optimal operation of automatic glare mode both the Vertical and Horizontal sensors need to be utilized for each elevation. At a minimum, one Vertical sensor must be mounted per elevation and additional sensors added if the sensor is mounted in an area with potential shading or a curved elevation.
PRODUCT OVERVIEW
The Vertical Exterior Sensor is used soley for automatic glare control and provides high-angle ambient light feedback to the controls system.
12-Conductor Cable
FrameCable
SageGlass® IGUs
SageBus™CableSensor Cable
Daylight Sensor SageGlass
Switch
FrameCable
Connection to AC Power
Terminal Box
Control Panel
Pigtail
Terminal Box
SAGE Electrochromics, Inc. 2 Sage Way • Faribault, MN 55021 USA
© SAGE Electrochromics, Inc. All rights reserved. SageGlass is a registered trademark of SAGE Electrochromics, Inc. SCS-014.2
PRODUCT DIMENSIONS
A mounting template and mounting screws are provided for the Vertical Exterior Sensor, providing the exibility to mount on various types of external surfaces. A sealing gasket is pre-applied to the Vertical sensor to ensure a water-tight seal to the outside surface. A 5/8” (16mm) hole is required for passing the sensor connector through the wall panel. If the sensor is located under a soffit or overhang the height-to-width ratio must be 4 to 1 (see Detail 3). Exact sensor placement will be determined on site.
The body of the Vertical sensor can be painted to enhance the aesthetics of the sensor. The translucent cover must be removed prior to painting and then replaced once the paint has dried. The cover must be attached in order for the sensor to receive accurate light readings.
INSTALLATION REQUIREMENTS
CE
RoHS certified
IP54 Rated
Sensor range: 56 to 5,574fc (600 to 60,000 lux)
RATINGS & CERTIFICATIONS
ORDERING INFORMATION
300-1112-001
SAGE PART NUMBER
Vertical Exterior Sensor
DESCRIPTION
SageGlass® is the pioneer of the world’s smartest dynamic glass and is transforming the indoor experience for people by connecting the built and natural environments. Electronically tintable SageGlass tints or clears on demand to control sunlight and prevent heat and glare without the need for blinds or shades. SageGlass dramatically reduces energy demand and the need for HVAC by blocking up to 91 percent of solar heat. As part of Saint-Gobain, SageGlass is backed by more than 350 years of building science expertise that only the world leader in sustainable environments can provide.
(877)724-3321
www.sageglass.com
GET IN TOUCH