weight training strength training for track & field
DESCRIPTION
Body Weight Circuits Used early in the preparatory period. One’s own body is used as the resistance. Examples Push-ups, sit-ups, pull- ups, prisoner squats Medicine Ball Circuits Jump-Run CircuitsTRANSCRIPT
WEIGHT TRAINING
Strength Training for Track & Field
Methods of Developing Strength
Circuit Training
Weight Training
Plyometrics
Body Weight Circuits Used early in the
preparatory period. One’s own body is
used as the resistance.
Examples Push-ups, sit-ups, pull-
ups, prisoner squats Medicine Ball Circuits Jump-Run Circuits
Weight Training Hypertropy Phase Basic Strength
Phase Strength-Power
Phase Peaking or
Maintenance Phase
Active Rest
Hypertropy Phase(General Preparation Phase)
High volume with low intensity Includes any work that tends to
increase muscle mass and muscle-nerve recruitment.
Moderate loads-50%-70% 8-10 repetitions. 3 to 6 sets. 3-4 sessions/week
Basic Strength Phase(Specific Preparation Phase)
Moderate volume with high intensity Goal is to increase maximum
dynamic strength. Heavy loads-80%-90%. 4-8 repetitions. 3 to 5 sets. 3 to 5 sessions/week.
Strength-Power Phase(Late Special Prep./Early Pre-Competition Phase)
Low volume with very high intensity Integrating power with strength activities. Emphasis on a combination of ballistic body
weight activities (plyos, multi-throws, etc.) with Olympic (snatch, clean, jerk, etc.) or power lifts (sqaut, bench press, deadlift, etc.)
Variable loads-60%-100% 2-3 repetitions/Olympic and up to 6
reps/power lifts emphasizing speed of movement.
3-5 sets 4-6 sessions/week.
Peaking or Maintenance(Competition Phase)
Low volume with very high intensity. In track, this usually involves
maintenance. of strength/power levels.
Heavy loads-90%-100%. 2-3 repetitions. 1 to 3 sets. 1-2 sessions/week.
Active Rest Take 2 to 4 days off 2-3 weeks of other activities or
very light technical work.
Weight Training Program Design
Rest Periods To stress the ATP-PC
system, rest after each exercise for four to seven minutes.
To stress the lactic acid system, rest less than one minute between exercises or after a group of exercises.
Rest PeriodsProgram A (ATP-PC) Program B (lactic acid)
Bench Press 10 Rest 4 min. 10 10 10Leg Press 10 Rest 4 min. 10 10 10Lat. Pull 10 Rest 4 min. 10 10 10Military Press 10 Rest 4 min. 10 10 10Leg Extension 10 Rest 4 min. 10 10 10Arm Curls 10 Rest 4 min. 10 10 10Leg Curls 10 Rest 4 min. 10 10 10
Rest 4 min. Rest 4 min.
Rest Periods Program A gives an example of rest periods
producing a primary stress on the ATP-PC system.
Program B gives an example of rest periods taken at the end of a circuit, primarily stressing the lactic acid system. Short rest could be taken between exercises with similar results.
One must understand the basic energetics of your events to design the correct rest intervals.
Choice of Exercise
Choice of exercise is usually related to:
1. Specific muscular movements related to the sport activity.
2. Those areas of the body most prone to injury.
Choice of ExerciseBody Part Exercises
Isolation of a muscle Bicep curl, military press,
etc.
Remember that every time you change the angle of an exercise you change that exercise.
Structural Exercises Use of many
muscles High pull, hang clean, etc.
Choose exercises which allow you to safely train a particular angle.
Choice of ExerciseWith all the possible exercises you could put into your program one needs to make a careful analysis of the exercises chosen. Analyze the needs of the sport and the athlete. Choose exercises which will best develop the angles and muscular characteristics desired. You can and should change exercises during the yearly cycle.
Order of Exercises
Basic questions to ask are:1. Does the workout progress from
arm to arm and leg to leg or arm to leg?
2. Does the workout progress from body part (small muscle group) to structural (large muscle group) or just the opposite?
Order of Exercises Beginners should
start out with a less severe workout order, thus arm to leg progression is appropriate.
Highly trained athletes may want a greater stress on the working muscles or a higher metabolic load and thus exercise orders may progress from arm to arm/leg to leg or small muscle groups to large muscle groups.
Example
Program A Single Leg Extension 10 10 10Hamstring Curl 10 10 10Squats 8 6 4
Pre-exhaustion, small muscle group before large muscle group.
Example
Program B Military Press 10 10 10Leg Press 10 10 10Bench Press 10 10 10Hack Squat 10 10 10
Typical arm to leg progression.
ExampleProgram CTriceps Extension 10 10 10Bench Press 8 8 8Single Leg Extension 10 10 10Hamstring Curl 10 10 10Squats 10 10 10
Arm to arm, leg to leg progression plus small to large muscle group progression.
Administrative Variables
The primary administrative variables are:
1. Equipment available.
2. Time available.
3. Number of individuals to train.
Equipment Available Gear your training
around what you have available. You can be creative by using manual resistance, plyometric, isometric or paired resistance substitutes if proper equipment is unavailable.
Time Constraints Try to pack into the
available time as much of the optimal stimulus as possible. (BE EFFICIENT)
As, stay with large becomes a factor time muscle group exercises & multi-joint exercises.
Number of Individuals to Train
Try to be very organized by having set patterns of movements and times at each exercise station; group teaching sessions on a lift need to be scheduled in order to avoid tying up equipment.