Wireless Configuration for VMC AN1020-21 Modem 1. Connect Power Adaptor 2. Connect RJ45 Cable from LAN PC / Laptop to Modem LAN 1 Port 3. Connect DSL RJ11 Cable to Splitter Line port 4. Connect RJ11 Cable from Splitter ADSL port to Modem DSL port 5. Power ON the Modem 6. Open Internet Explorer and type http://192.168.1.1 press enter 7. Enter username: admin 8. Enter password: admin

9. Click on “Configuration” then Click on “Wireless connection”

10. “Enable” Wireless Network 11. In security Settings, Select Security option as “Wi-Fi Protected Access” 12. Select Encryption Protocol as “TKIP Protocol” 13. Select Authentication Method as “PSK (Pre Shared Key)” 14. Enter Security key on “WPA Pass phrase” Example: “bsnl1234” Note: WPA pass phrase should be 8 – 63 Characters long 15. Click on “Confirm” to Save the Changes

16. Now Click on “Mac Address Filter”

17. Select MAC Auth as “Disabled” 18. Click on “Apply” to save changes.

Configuration on Laptop / Wireless PC

1. Open “Network Connections” page to configure Wireless Network Adaptor

2. Right Click on “ Wireless network Connection” & select “ View

Available wireless Connections”

3. We will see the below window.

4. Select “ BSNL_AP” & click on “ Connect”

5. It will ask for network Key & Confirm Network Key. Enter Network

key as you defined in Modem wireless configuration. Example: “bsnl1234”

6. Click on Connect to establish wireless connection.

7. Laptop / PC successfully Established wireless Connection.