wireless power transmission -dileep
DESCRIPTION
SEMINAR ON WPTTRANSCRIPT
DEPARTMENT OF
ELECTRICAL AND
ELECTRONICS ENGINEERINGEEE NMIT 20141
WIRELESS POWER TRANSFER
EEE NMIT 20142
overview
EEE NMIT 20143
What is wireless power transfer
History
Why not wires..?
Why wireless…?
Principle
Methods of WPT
Merits and demerits
Biological Impact
Application
Conclusion
Reference
What is Wireless power transfer
EEE NMIT 20144
The transmission of energy from one place to
another without using wires.
Solution is WiTricity.
WPT emerges out as the best alternative for
efficient power transmission.
EEE NMIT 20145
HISTORY Nikola Tesla -Pioneer of induction techniques
His vision for “World Wireless System”
In 1894 Nikola Tesla used resonant inductive coupling, also
known as "electro-dynamic induction" to wirelessly light up
incandescent lamps .
1897 he patented a device called
high-voltage resonance transformer or"Tesla coil” capable of
producing
very high voltagesat high frequency.
In 1899 - an aerial tower called Wardenclyffe .
which was meant to be a pilot plant for his “World Wireless
System” to broadcast energy around the globe.
The idea of Tesla is taken in to research after 100 years in 2007.
Nikola Tesla (1856 - 1943)
Why Not Wires ?
EEE NMIT 20146
As per studies, most electrical energy transfer is
through wires.
Most of the energy loss is during transmission
On an average, more than 30%
In India, it exceeds 40%
Risk of electrical hazards
Complicated wiring structure
Maintenance cost is high.
Why wireless…?
EEE NMIT 20147
Reliable
Efficient
Fast
Low maintenance cost
Can be used for short-range or long-range.
Method Of WPT
EEE NMIT 20148
There are mainly 5 method to transfer power
Inductive Coupling
Air Ionization
LASER power transmission
Resonant Inductive Coupling
Microwave Power Transmission (MPT)
EEE NMIT 20149
Short range – INDUCTIVE COUPLING, AIRIONIZATION
LASER POWER TRANSMISSION
Medium range – RESONANT INDUCTION
Long range power transfer – MICROWAVE POWER
TRANSMISSION
For the application of
Inductive coupling
EEE NMIT 201410
The principle of mutual induction between two coils
can be used for the transfer of electrical power.
The simplest example is
transformer
where there is no physical contact
between the primary and the secondary
coils
Air ionization
EEE NMIT 201411
Toughest technique under near-field energy transfer
techniques
Air ionizes only when there is a high field
Needed field is 2.11MV/m
Natural example: Lightening
Not feasible for practical implementation
Laser power transmission
EEE NMIT 201412
LASER is highly directional, coherent
Simple receiver
Photovoltaic cell
Cost-efficient
Not suitable for very long
gets attenuated when it propagates through
atmosphere
Need of Resonance coupling
EEE NMIT 201413
transformers work on the principle of inductive coupling, short range power transfer & requires a magnetic core.
Over greater distances this method is highly inefficient and wastes the majority of the energy in resistive losses of the primary coil.
concept of resonant coupling comes where two coils are tuned to a particular frequency called resonating frequency & absorb optimal energy.
Resonant inductive coupling
EEE NMIT 201414
The capacitor and inductor forms the resonator.
Charge oscillates between inductor (as magnetic
field) and capacitor (as electric field.)
This type of oscillation is called resonance if the
reactance's of the
inductor and capacitor are equal.
BLOCK DIAGRAM RIC
EEE NMIT 201415
RIC continue…..
EEE NMIT 201416
This wireless power transmission concept based on strongly-coupled resonator.
Time taken for energy transfer is less than the time of loss . So high efficiency.
Since the resonant wavelength is much larger than the resonators, the field not need of line-of-sight.
This method is safe, since magnetic fields interact weakly with living organisms..
Microwave Power
Transfer(MPT)
EEE NMIT 201417
In this method Electrical energy is converted to microwave energy.
AC is converted to DC first then this DC is converted to microwaves using magnetron.
This wave is Captured using rectenna and convert Microwave energy to electrical energy.
THIS Methord is used where transfers high power from one place to another being in line of sight usually.
MPT(Continued….
)
EEE NMIT 201418
Rectenna:
Transmitted waves are received at rectenna.
Consists of mesh of dipoles and diodes
Converts microwave to its DC equivalent
DC is converted back to AC
Usually multi-element phased array
Eg. Solar power satellite
Solar Power
Satellite
Merits of WPT
EEE NMIT 201419
Eliminates the existing transmission line cables, towers and sub stations
More freedom of choice of both receiver and transmitters
Cost of transmission and distribution become less.
Power could be transmitted to the places where the wired transmission is not possible.
Loss of transmission is negligible level.
Safer by eliminating the sparking hazard.
EEE NMIT 201420
More Reliable/Less Costly- Never run out of battery power in wireless zones
- Power transfers more efficiently than through wires
More Convenient- No more changing batteries
- No messy cords to carry.
Environmentally Friendly- Reduces the use of disposable batteries
- Reduces energy loss
Demerits
EEE NMIT 201421
The Capital Cost for practical implementation of WPT seems to be very high.
Interference of microwave with present communication systems
Common belief fears about the effect of microwave radiation among peoples
When LASERs are used,
conversion is inefficient
Absorption loss is high
Biological Impact
EEE NMIT 201422
Institute of Electrical and Electronic Engineers
(IEEE) and by the International Commission on Non-
Ionizing Radiation Protection (ICNIRP).
Experimently prooved that
no radio frequency (RF) electromagnetic fields
causes cancer,
but there is a very small increase a person’s body
temperature or may heat body tissues and may
stimulate nerve and muscle tissues.
Is WiTricity Secure ?
EEE NMIT 201423
Principle is based on Magnetic Waves.
The question is if Magnetic Waves Secure ?
The answer is we all live in a globe that has already
surrounded by magnetic waves.
Yes it is secure !
Applications
EEE NMIT 201424
Wireless electricity can be used to power or recharge:
1:Electric Cars
2,Used to charge Electrical and Electronics gadgets
EEE NMIT 201425
Mobile phones ,laptops, television,
Schematic representation of the functional benefits of wireless
energy transfer based on HR-WPT.
EEE NMIT 201426
3, Medical Devices
EEE NMIT 201427
Pictures showing two examples of HR-WPT charging
applications in medical
devices: Left ventricular assist device (LVAD) (left)
and pacemakers (right).
4,home electrification
EEE NMIT 201428
6, Led lighting
EEE NMIT 201429
LED (light emitting diode) lights can be directly powered with
wireless electricity ,which eliminate
the need for batteries enabling architectural lighting
designers to create products that seemingly float in mid-air,
with no power cord.
Defense Systems
EEE NMIT 201430
Photographs showing several military applications for
highly resonant wireless
charging systems: military robots (left) and soldier
electronics (right).
Future of WiTricity
Think that the city will be covered with WiTricity hot
spots like wi-fi.
which eliminate need of charging batteries or carrying
adapters all around !
Transport system become wirelessly powered
which eliminate fuel engines.
Which will give rise to the Robotic Technology
they will work for us 24 H 365 days without any
failure.31 EEE NMIT 2014
Conclusion
EEE NMIT 201432
Transmission without wires- a reality
Efficient
Low maintenance cost. But, high initial cost
Better than conventional wired transfer
Energy crisis can be decreased
Low energy wastage
In near future, world will be completely
wireless
Reference
EEE NMIT 201433
Highly Resonant Wireless Power Transfer:
Safe, Efficient, and over Distance by Dr. Morris Kesler
WiTricity.“Wireless Power Transmission”, Vol No.-45, Electronics For
U –August-2013
Peter Vaessen,” Wireless Power Transmission”, Leonardo
Energy, September 2009
C.C. Leung, T.P. Chan, K.C. Lit, K.W. Tam and Lee Yi Chow,
“Wireless Power Transmission and Charging Pad”
White Paper on Solar Power Satellite (SPS)
Systems, URSI, September 2006
Richard M. Dickinson, and Jerry Grey, “Lasers for
Wireless Power Transmission”
David Schneider, “Electrons unplugged”, IEEE
Spectrum, May 2010
EEE NMIT 201434
Thanks For
Listening…………….!!!
EEE NMIT 201435