WELDING WELDING INSPECTIONINSPECTION

TECHNOLOGYTECHNOLOGYWORKBOOKWORKBOOK

THIRD EDITION

Published ByAmerican Welding Society

Education Department

DISCLAIMER

The American Welding Society, Inc. assumes no responsibility for the informationcontained in this publication. An independent, substantiating investigation should bemade prior to reliance on or use of such information.

International Standard Book Number: 0-87171-477-9Copyright © 1995 by American Welding Society, Miami, FloridaThird Edition 1999Revised 7/99

All rights reserved. No part of this book may be reproduced in any form or by any means,electronic or mechanical, including photocopying, recording, or by any informationstorage or retrieval system, without permission in writing from the publisher.

Printed in the United States of America

WELDING INSPECTION TECHNOLOGYWELDING INSPECTION TECHNOLOGYWORKBOOKWORKBOOK

MODULE 1MODULE 1

WELDING INSPECTION WELDING INSPECTION ANDANDCERTIFICACERTIFICATIONTION

1-1

Q1-1 Why is there an increasing need for weld quality?a. safetyb. economicsc. less conservative designd. government regulationse. all of the above

Q1-2 What AWS document describes the rules for the CWI certification program?a. AWS 5.5b. AWS D1.1c. AWS QC-1d. AWS 5.1e. AWS 14.1

Q1-3 Weld quality control should begin after welding has been initiated.a. trueb. false

Q1-4 What are the three welding inspector certifications covered in AWS QC-1?a. CAWI, CWI, BWIb. CWI, CAWI, SCWIc. SCWI, CWI, ACWId. Level I, II, and IIIe. None of the above

Q1-5 What is generally considered to be the most important quality of a welding inspector?a. graduation from a welding vocational programb. an engineering degreec. an associate degreed. professional attitudee. hold a certified welder certificate

Q1-6 The vision requirements for a CWI are near vision acuity on:a. Jaeger J1 at 24 inchesb. Jaeger J2 at 12 inchesc. Jaeger J2 at 12 inches, with or without corrective lensesd. the inspector cannot wear glassese. 20/20 vision

Q1-7 The acronym KASH stands for:a. knowledge, attitude, skills, and habitsb. knowledge, application, skills, and habitsc. knowledge, attitude, skills, and honestyd. knowledge, application, skills, and honestye. knowledge, attitude, sincerity, and honesty

1-2

Welding Inspection Technology WorkbookModule 1—Welding Inspection and Certification