04/19/23 18:16

with Barcode Reader

04/19/23 18:16

with Barcode Reader

Selection of barcode reader

1a.

Select the button „Configuration“.

04/19/23 18:16

with Barcode Reader

1b.

Click in the area which is coloured green in the drawing.

This is the base configuration area.

04/19/23 18:16

with Barcode Reader

1c.

Click the check box „Barcode reader“, so that it is checked.

Hint:With „Barcode reader“ checked the „Edit mode“ box within the „Create Order Files“ window is hided. The barcode reader reads the ID and type. Manual input is not necessary.

04/19/23 18:16

with Barcode Reader

1d.

Check the Barcode reader serial port.

Hint:In this example the cable is connected with Com Port 2.

Click „OK“.

04/19/23 18:16

with Barcode Reader

Destination Selection Mode

2a.

Select in the menu „Edit settings“.

In the next screen we distinguish two cases:

Case 1: Working with automatic destination assignment.

Case 2: Working with manual destination assignment.

04/19/23 18:16

with Barcode Reader

Case 1: Working with automatic destination assignment:Click the box, so that it is unchecked.Enter the matrix type.

WD6216                       

WP24211                       

WH12@1MM209B                      209B@209B

WH12@WH12DS209                        209@209

WH12WH12@WH12DR

205MI

854B668

205                       

853B853B@209

203                       

526B526B@209B

202                       

348B                    201                       

306B                    200                       

304B                   

Rack/WellplateType on Barcode

(.........# )

Case 2: Working with manual destination assignment:Click the box, so that it is checked.

04/19/23 18:16

with Barcode Reader

Start Automation

• Initializing / Home seeking

• Reading barcodes

• Create orders without SampleTrack

• Verify orders

• Preparation

3a.

Click the green button to start automation.

04/19/23 18:16

with Barcode Reader

3b.

The program asks, if the barcodes should be read. Click „Yes“, if you run the program in a new setting.

04/19/23 18:16

with Barcode Reader

Case 1: Working with automatic destination assignment

The destination checkbox is hided and the destination is defined by program.

Case 2: Working with manual destination assignment

The destination must be selected.

04/19/23 18:16

with Barcode Reader

4a.

Case 1: Working with automatic destination assignment:

• Select the source tubes with a lasso operation:

• Click and hold the left mouse cursor. Draw a rectangle.

• The marked positions will be shown as orders.

04/19/23 18:16

with Barcode Reader

Click „Create Orders“.

Click „OK“.

04/19/23 18:16

with Barcode Reader

5.

The orders are running.