wls lighting systems mirr series mirr led area ordering information ue - universal voltage (120-277)...
TRANSCRIPT
SERIESMIRRDISTRIBUTION/PERFORMANCE - Proprietary silicone refractor optics provide exceptionalcoverage and uniformity in Types 2, 3, 5W and FT. Internal Louver (IL) option available forimproved back-light control without sacri�cing street side performance.
ENERGY SAVING CONTROL OPTIONS - DIM - 0-10 volt dimming enabled with controls byothers.
OCCUPANCY SENSING - Optional integral passive infrared motion and daylight sensoractivates switching of luminaire light levels. High level light is activated and increased to fullbright upon detection of motion. Low light level (30% maximum drive current) is activatedwhen target zone is absent of motion activity for ~2 minutes. Sensor is located on thecenter of the access cover and has a detection cone of approximately 45°.
LEDS - Select high-brightness LEDs in 5000K, 4000K, and 3000K color temperature, 70 CRI.
HOUSING - Rugged die-cast aluminum housing contains factory prewired driver and opticalunit. Cast aluminum wiring access door located underneath. Fixture sealed to IP65.
MOUNTING -Tapered rear design allows �xtures to be mounted in 90° and 120°con�gurations without the need for extension arms. Use with 3” reduced drilling pattern.Wall mount brackets are available for direct mounting to wall.
ELECTRICAL - Two-stage surge protection (including separate surge protection built intoelectronic driver) meets IEEE C62.41.2-2002, Location Category C. Available with universalvoltage power supply 120-277 VAC (50/60Hz input), and 347-480 VAC. Optional PCR andphotocells (PC) are available in 120, 208, 240, 277, 347 and 480 volt (supply voltage mustbe speci�ed).
DRIVER - Available in various lumen output packages. Components are fully encased inpotting material for moisture resistance. Driver complies with FCC standards. Driver andkey electronic components can easily be accessed.
OPERATING TEMPRATURE - -40°C to +50°C (-40°F to +122°F)
FINISH - Fixtures are �nished with polyester powder coat �nishing process.The �nish withstands extreme weather changes without cracking or peeling.
SHIPPING WEIGHT (in carton) - One �xture: 40 lbs. (18.1 kg).
LISTINGS - UL listed to U.S. and international safety standards. Suitable for wet locations.For a list of the speci�c products in this series that are DLC listed, please consult the LEDLighting section of our website or the Design Lights website at www.designlights.org.
WARRANTY - MIRR LED �xtures carry a limited 5-year warranty.
SPECIFICATIONS
Approved By: Project Name:
Location: Date:
800.633.8711 www.wlslighting.com1919 Windsor Place Fax: 817.735.4824 Fort Worth, TX 76110
WLS LIGHTING SYSTEMS
Speci�cations subject to change without notice. 01 Rev. 11/16
LED AREA
DIMENSIONS
ARRAFunding Compliant
wet locatio n
IP65
Fixtures comply with ANSI C136.31-2010 American National Standard for Roadway Lighting Equipment - Luminaire Vibration 1.5G requirements.
DIMENSIONS33"
(838mm)
18-13/16"(477mm)
7-9/16"(192mm)
16"(406mm)
IMS MOTION &DAYLIGHT SENSOR
7-5/16"(186mm)
PHOTOCONTROLRECEPTACLE
Mounting
MIRR LED AREA
ORDERING INFORMATION
UE - Universal Voltage (120-277)347 - 480 - Universal Voltage (347-480)
18 - 18,500 Lumens29 - 29,300 Lumens35 - 35,300 Lumens
MIRR
ORDER:
LED
WLS-MIRR
SERIES DISTRIBUTION SOURCE CURRENT TEMPERATURE VOLTAGE FINISH OPTIONS ACCESSORIES
LIGHT DRIVE COLOR LINE LUMINAIRE
FOOTNOTES:
SERIES
MIRR 2 LED 35 50 UE BRZ IL NA(EXAMPLE ORDER)
DIM - 0-10 Volt Dimming (from external signal) 1BLS - Bi-level Switching (from external signal) 1IMS - Integral Motion & Daylight Sensor 2,3PCR - Photoelectric Control Receptacle 4IL - Internal Louver Backlight ShieldingNO - No Options
BRZ - BronzeBLK - BlackGPT - GraphiteMSV - Metallic SilverWHT - WhitePLP - Platinum PlusSVG - Satin Verde GreenCC - Custom Color
2 - Type II3 - Type III5W - Type V WideFT - Type IV
SELECT APPROPRIATE CHOICE FROM EACH COLUMN TO FORMULATE ORDER CODE. Refer to example below.
Approved By: Project Name:
Location: Date:
800.633.8711 www.wlslighting.com1919 Windsor Place Fax: 817.735.4824 Fort Worth, TX 76110
Speci�cations subject to change without notice. 01 Rev. 11/16
50 - 5000K40 - 4000K30 - 3000K
PC - Photocell for use with PCR 5,7IMS/PC - Remote Con�gurator ToolSF - Single Fusing 6,7DF - Double Fusing 6,7IL - Integral Louver (HSS)WM - Wall Mount BracketNA - No Accessories
1- Not compatible with IMS.2- Not compatible with DIM, BLS or Wireless Control Systems.3- IMS is a Watt Stopper Dual Sensor (Daylight & Motion) which is �eld adjustable via a hand held remote illustrator tool, which must be ordered separately.
4- Photocell must be ordered separately. 7 pin standard. See Accessories.5- Factory installed PCR option required.6- Fusing must be located in hand hole of pole.7- Specify voltage.
Type 2, Type 5W, Type 3 and Type FT
LIGHT OUTPUT - MIRR - Type 5W - 5000K CCTLumens (Nominal) Watts
(Nominal)
5000
K40
00K
3000
K
LED Chips are frequently updated therefore values may increase.
17100
25300
31700
18300
28000
33000
18500
29300
35300
154
242
315
154
242
315
154
242
315
18
29
35
18
29
35
18
29
35
LUMINAIRE EPA CHART - MIRR
Single
D180°
D90°
T90°
TN120°
Q90°
0.6
1.1
0.9
1.9
1.9
2.1