Wrap It Around Bracelet Materials • 16 yds of fingering weight yarn (I used

Newton’s Yarn Country “Panda”) • 2 DPNs, size 1 • 10 metallic beads • 1 toggle bar & ring clasp Gauge Gauge is not important to this pattern Instructions For i-cord instructions, see http://www.purlbee.com/i-cord-tutorial/ Cast on 3 stitches. Leave a tail of at least 6”. Create an i-cord 44” long. Knit the 3 sts together and draw the tail through the last stitch. Pull tight. Cut the yarn, leaving a tail of at least 6”. Thread 10 beads on the i-cord, spacing them out about every four inches.

Using the tail, attach one end of the i-cord to the toggle bar. Knot tightly, and pull the end through the center of the i-cord. Repeat to attach the toggle ring to the other end of the i-cord. Wrap the bracelet around your wrist 5 or 6 times and fasten by pulling the toggle bar through the ring. Enjoy!

All Photos and Content © 2013 by Karen Catlin. All rights reserved. Questions, comments? Email me at karen@knitoutsidethebox.com.

Visit me on the web at http://www.knitoutsidethebox.com