written by: randall heath · nikon d3000 lcd screen replacement this guide is intended to show the...

Nikon D3000 LCD Screen ReplacementThis guide is intended to show the steps necessary to remove and replace the LCD screen.

Written By: Randall Heath

Nikon D3000 LCD Screen Replacement Draft: 2016-01-05Guide ID: 50224 -

This document was generated on 2019-09-18 10:55:05 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com of 7

INTRODUCTION

If you're looking for a simple step-by-step guide to help you replace the LCD screen on your NikonD3000, this is a great place to start! If the LCD screen has been cracked, chipped or broken, thecamera will need to be disassembled before the screen can be replaced.

TOOLS:Phillips #00 Screwdriver (1)Metal Spudger (1)Masking Tape (1)Spudger (1)iFixit Opening Tools (1)

PARTS:Nikno D3000 LCD Screen (1)




http://www.amazon.com/ScotchBlue-Painters-Multi-Use-94-Inch-60-Yard/dp/B00004Z4CP/ref=sr_1_1?s=industrial&ie=UTF8&qid=1409007099&sr=1-1&keywords=masking+tape

http://www.flex-007.com/lcd-display-screen-for-nikon-d3000-digital-camerabrand-new-p-3610.html?lp=pla-us2&product_id=LCD00771&kw=&adposition=1o2&gclid=CjwKEAjw4s2wBRDSnr2jwZenlkgSJABvFcwQwicY41OAkoQ_UKuZwCBymRMqHh3yzccw8QMOFUHrCBoCZ-fw_wcB

Step 1 — LCD Screen

Removal of the screws from thebottom will aid in the removal of theback as it loosens the bottom tabs ofthe camera back.

Remove three 3 mm x 2.5 mmPhillips head screws from thebottom right back of the camerabottom.

Remove one 3 mm x 5.5 mm Phillipshead screw from the bottom left ofthe camera bottom.

Step 2

Remove two 3 mm x 5.5 mm Phillips head screws from either side of the viewfinder.

Remove four 3 mm x 5.5 mm Phillips head screws above and below the USB port cover and aboveand below the SD card slot cover.

Remove two 3 mm x 4 mm Phillips head screws inside the SD card slot cover.




Step 3

Gently lift the back of the camera off, starting with the top first.

Lift off the bottom slightly to expose the ribbon connector connecting the back of the LCD screento the motherboard of the camera and lift the black tab on the ribbon connector.

Pull the ribbon away from the connector to disconnect the back panel from the main body of thecamera.




Step 4

Use the black plastic spudger to push the black tab towards the lower ribbon. The black tab on thesmaller ribbon should slide out of place.

Lift the white tab on the larger ribbon.

Gently disconnect both ribbons.




Step 5

Remove six 5 mm x 4mm Phillips head screws , then remove the metal plate housing the LCD fromthe plastic camera backing.




To reassemble your device, follow these instructions in reverse order.

Step 6

Cover the old LCD Screen with tape before removing to avoid broken glass if the screen cracksduring removal.

Use the metal spudger to detach the LCD screen from the metal plate that is held down by theadhesive.

Install new LCD screen




written by: randall heath · nikon d3000 lcd screen replacement this guide is intended to show the...

Documents