xbox repair - the do it yourself guide to xbox repair
TRANSCRIPT
Xbox Repair - The Do it Yourself Guide to Xbox Repair
o your console is dealing with some kind of dilemma with the firmware flash
o there is a issue with the southbridge chipset, which is found on the motherboard
Switch your Xbox over and unscrew the screws holding it together four screws are
underneath the rubber pads so gently peel them a small little bit off so you can get to the
screws. I wouldn't peel them all the way off they might not adhere again on. They also have
some screws beneath the stickers so unscrew people as well. You will require a Torx head
screw driver you can get a established from most device outlets. Now flip the Xbox
appropriate aspect up and pull the prime off it might get some wiggling and wrangling due to
the fact it is on there pretty limited.
Phase #3 Using Out The DVD Player
Up coming unscrew the middle plastic divider that holds the Hard Travel. We aren't going to
do something with it but you can't get to the DVD with it there. You could disconnect the
Difficult Generate and get it out of the way but I just variety of depart it related but hang it
exterior the Xbox scenario. This tends to make it less complicated to place back again
collectively afterwards. Now that that's out of the way search for two screws connecting the
plastic DVD holder to the Xbox casing, unscrew them. Consider out the whole issue.
Action #4 Opening the DVD Generate
Pull the DVD Drive out of it's plastic holder and turn it upside down unscrew all the screws.
Holding it jointly change it upside up once more (we don't want to drop any elements). Now
take the best off seem for a small rubber belt this is more than most likely the culprit. As the
DVD Generate will get older the rubber belt gets looser and more dirty so it doesn't operate
so good any longer.
Action #5 Take Out The Belt
Relying on what DVD push your Xbox employs this could be quite straightforward or could
call for some ability. If you a can get to it with your finger attempt to pull it out carefully. We
don't want split any gears within. If you cannot get to it with your fingers consider some
tweezers to pull it out.
Action #six Cleaning and Tightening The Belt
These rubber belts get free and dirty in excess of time. To resolve it try out the following. Get
out a espresso cup and fill it with h2o set it in the microwave for one to two minutes. Get it
out of the microwave and set the rubber belt in the drinking water this will thoroughly clean
the belt and would seem to also make it shrink back a small. Enable the drinking water
amazing a little bit and dry off the belt and spot it back in the DVD push. Now screw the DVD
travel again together and set the Xbox back again jointly once more and test it.
If it still doesn't perform you may possibly have to purchase a new rubber belt take the
broken one particular to an electronics retailer and ask them to find you a match. Exchange it
and try once more.
xbox 360 repair