yyz - y/z motors + y endstop - amazon web services · yyz - y/z motors + y endstop we install the y...
TRANSCRIPT
YYZ - Y/Z Motors + Y EndStopWe install the Y and Z motors, and also the Y EndStop. These components go together
because the wires run together on the inner back.
YYZ - Y/Z Motors + Y EndStop
© 2018 docs.imade3d.com/ Page 1 of 11
Step 1 — YYZ - Y/Z Motors + Y EndStop
Y Motor Bracket
Y EndStop
Z Motor with a leadscrew
…and related wires
YYZ - Y/Z Motors + Y EndStop
© 2018 docs.imade3d.com/ Page 2 of 11
Step 2 — Attach the Z Motor
M3x45 screws.
Make sure the connector on the Z Motor is facing towards the back of the acrylic unit.
You don't need to accurately position the motor at this stage; just tighten the screws a bit so the motordoesn't flap around.
YYZ - Y/Z Motors + Y EndStop
© 2018 docs.imade3d.com/ Page 3 of 11
Step 3 — Attach the Y Motor
Snap the Y Motor into place (with the pulley facing down) right under the power supply connector.
YYZ - Y/Z Motors + Y EndStop
© 2018 docs.imade3d.com/ Page 4 of 11
Step 4 — Attach the Y EndStop
Y EndStop
M2x16 screw (2)
Regular M2 nut (2)
Make sure the head of the screw is on the switch (so that the nut is on the underside the printer.)
YYZ - Y/Z Motors + Y EndStop
© 2018 docs.imade3d.com/ Page 5 of 11
Step 5 — Wire it All Up
Y endstop wire.
YYZ - Y/Z Motors + Y EndStop
© 2018 docs.imade3d.com/ Page 6 of 11
Step 6
Y motor wire.
YYZ - Y/Z Motors + Y EndStop
© 2018 docs.imade3d.com/ Page 7 of 11
Step 7
Z motor wire
There are two Z motors connectors on the RAMPS board, so you can drive two motors. if you wish so.You can pick either the top or the bottom row, it makes no difference if you only have one Z motor.
YYZ - Y/Z Motors + Y EndStop
© 2018 docs.imade3d.com/ Page 8 of 11
Step 8
All connected. It's time to tidy it up the wires.
YYZ - Y/Z Motors + Y EndStop
© 2018 docs.imade3d.com/ Page 9 of 11
Step 9 — Bottom Wires Attachment
4'' zip ties
Don't pull on the Y motor connector. Leave there a bit of slack.
It’s crucial the Y motor and Y endstop wires are attached so that they cannot come in contact with thebed.
The zip tie heads must be on the underside of Bottom.
YYZ - Y/Z Motors + Y EndStop
© 2018 docs.imade3d.com/ Page 10 of 11
This document was last generated on 2018-06-22 05:32:22 PM.
Step 10 — Wires Inner Back Attachment
4'' zip ties
YYZ - Y/Z Motors + Y EndStop
© 2018 docs.imade3d.com/ Page 11 of 11