1 synthetic-aperture radar (sar) image formation processing
TRANSCRIPT
1
Synthetic-Aperture Radar (SAR) Image Formation Processing
2
OutlineRaw SAR image characteristics
Algorithm basicsRange compression
Range cell migration correction
Azimuth compression
Motion compensation
Types of algorithmsRange Doppler algorithm
Chirp scaling algorithm
Frequency-wavenumber algorithm (-k or f-k)
Comparison of algorithmsProcessing errors, Computational load, Pros and cons
Autofocus techniques
3
Airborne SAR real-time IFP block diagram
Image-Formation Processor
New terminology:Presum (a.k.a. coherent integration)Corner-turning memory (CTM)Window Function
Focus and Correction VectorsRange Migration and Range WalkFast Fourier transform (FFT)Chirp-z transform (CZT)
4
Basic SAR image formation processes
5
Basic SAR image formation processes
6
Basic SAR image formation processes
7
Basic SAR image formation processes
8
Basic SAR image formation processes
9
Optical image-formation processing
10
Demodulated baseband SAR signal[from Digital processing of synthetic aperture radar data, by Cumming and Wong, 2005]
Time domain representationAfter removing the radar carrier cos(fo) from the received signal, the demodulated, complex, baseband signal from a single point target can be represented as
where :range (fast) time, s :azimuth (slow) time relative to the time of closest approach, sAo:complex constantwr( ):envelope of the transmitted radar pulsewa( ):antenna’s azimuth beam patternR( ):slant range in time domain, mc :beam center crossing time relative to the time of closest approach, sfo:carrier frequency, HzKr :FM rate of transmitted pulse chirp, Hz/s
11
Demodulated baseband SAR signalincludes R-4 and
target RCS factors
Vr :effective radar velocity (a positive scalar), m/s
Ro:slant range at closest approach, m
transmit waveform amplitude
antenna gain variation over synthetic aperture
range-dependent phase component
quadratic phase term due to transmitted chirp waveform
The instantaneous slant range is
where
12
SAR signal spectrum[from Digital processing of synthetic aperture radar data, by Cumming and Wong, 2005]
Frequency-domain representionFor reasons of efficiency, many SAR processing algorithms operate in the frequency domain.
For the low-squint case, the two-dimensional frequency spectrum of the received SAR signal is
where 2df, the phase function in the two-dimensional
frequency domain, is
and Ka´, the azimuth FM rate in the frequency domain, is`
13
SAR signal spectrumAlso
f :range frequency, Hz, where –Fr /2 f Fr /2
Fr : range sampling frequency, Hzf : azimuth (Doppler) frequency, Hz
fc :absolute Doppler centroid frequency, Hz
Wr(f ) :envelope of the radar data’s range spectrum
Wa(f ) :envelope of the antenna’s beam pattern Doppler spectrum
The relationship between azimuth time to frequency is
where
14
SAR signal spectrumenvelope of the
radar data’s range spectrum
antenna’s beam pattern envelope in Doppler spectrum
phase function in two-dimensional frequency domain
quadratic phase term due to
azimuth chirp
range-dependent phase component
quadratic phase term due to
transmitted chirp
15
Matched filter processingGiven an understanding of the characteristics of the ideal SAR signal, an ideal matched-filter can be applied using correlation to produce a bandwidth limited impulse response.
However this process has limitations as the characteristics of the ideal matched-filter varies with the target’s position in range and azimuth.
So while such correlation processing is theoretically possible, it is not computationally efficient and is not appropriate when large-scale image-formation processing is required, e.g., from a spaceborne SAR system.
16
Range Doppler domain spectrum[from Digital processing of synthetic aperture radar data, by Cumming and Wong, 2005]
Range Doppler-domain representationThe range-Doppler domain is useful for range-Doppler image formation algorithms.
The range-Doppler domain signal is
where rd, the azimuth phase function in the range-Doppler
domain, is
and Rrd(f ), the slant range in the range-Doppler domain,
represents the range cell migration in this domain
17
Range migration
18
Range-dependent range migrationBaz :azimuth bandwidthBr :transmitted pulse bandwidtho :azimuth time when target perpendicularc :azimuth time when target in epicenter of azimuth signaltv() :time delay between Tx and Rx signal, = 2R( )/cR(o ) :azimuth time-dependent distance
19
Range-Doppler processing
20
Range-Doppler processing
21
Range-Doppler processing
22
Range-Doppler algorithm
RCMC: range cell migration compensation SRC: secondary range compression
Range cell migration compensation (RCMC) is
performed in the range-Doppler domain. Families of target
trajectories at the same range are transformed into a single trajectory that runs parallel to the azimuth frequency axis.
23
Range-cell migration compensationPart of the migration compensation requires a re-sampling of the range-compressed pulse using an interpolation process.
24
Chirp scaling algorithmThe range-Doppler algorithm was the first digital algorithm developed for civilian satellite SAR processing and is still the most widely used.
However disadvantages (high computational load, limited accuracy secondary-range compression in high-squint and wide-aperture cases) prompted the development of the chirp-scaling algorithm to eliminate interpolation from the range-cell migration compensation step.
As the name implies it uses a scaling principle whereby a frequency modulation is applied to a chirp-encoded signal to achieve a shift or scaling of the signal.
25
Chirp scaling algorithm
26
Chirp scaling algorithm
27
Chirp scaling algorithm
28
Chirp scaling algorithm
29
Chirp scaling algorithm
30
Range-cell migration compensation
31
Omega-K algorithm (WKA)The chirp-scaling algorithm assumes a specific form of the SAR signal in the range Doppler domain, which involves approximations that may become invalid for wide apertures or high squint angles.
The Omega-K algorithm uses a special operation in the two-dimensional frequency domain to correct range dependent range-azimuth coupling and azimuth frequency dependence.
The WKA uses a focusing step wherein a reference function is multiplied to provide focusing of a selected range. Targets at the reference range are correctly focused while targets at other ranges are partially focused.
Stolt interpolation is used to focus the remainder of the targets.
32
Omega-K algorithm (WKA)Illustration of the range/azimuth cross coupling using the raw phase history from a point target.Range-cell migration introduces a phase change into the azimuth samples in addition to the normal phase encoding.The RCM cross coupling creates an additional azimuth phase term which affects the azimuth FM rate.
2C
2
Tk5.0tTkTf2cos2
a)t(s From chirp pulse
compression exampleRange-dependent
phase terms
33
Omega-K algorithm (WKA)
34
Stolt interpolation
35
Stolt interpolation
36
Stolt interpolation
37
Comparison of IFP algorithms
Azim MF: azimuth matched filter
Hyperb: hyperbolicP.S.: power series, i.e., parabolic
RCMC: range cell migration correction
SRC: secondary range compression
38
Motion compensationImperfect trajectories during SAR data collection will distort the data set resulting in degraded images unless these imperfections are removed.
Removal of the effects of these imperfections is called motion compensation.
Motion compensation requires precise knowledge of the antenna’s phase center over the entire aperture.
• For example vertical velocity will introduce an additional Doppler shift into the data that, if uncompensated, will corrupt along-track processing.
• Similarly a variable ground speed will result in non-periodic along-track sampling that, if uncompensated, will also corrupt along-track processing.
Knowledge of the antenna’s attitude (roll, pitch, yaw angles) is also important as these factors may affect the illumination pattern as well as the position of the antenna’s phase center.
39
Motion compensationTo provide position and attitude knowledge various instruments are used
Gyroscopes (mechanical or ring-laser)
Inertial navigation system (INS)
Accelerometers
GPS receiver
40
Motion compensation
41
Motion compensationIn addition to position and attitude knowledge acquired from various external sensors and systems, the radar signal itself can provide information useful in motion compensation.
The Doppler spectrum can be used to detect antenna pointing errors.
The nadir echo can be used to detect vertical velocity (at least over level terrain).
42
AutofocusJust as non-ideal motion corrupts the SAR’s phase history, the received signal can also reveal the effects of these motion imperfections and subsequently cancel them.
This process is called autofocus.
Various autofocus algorithms are available
• Map drift
• Phase difference
• Inverse filtering
• Phase-gradient autofocus
• Prominent point processing
Many of these techniques exploit the availability of a high-contrast point target in the scene.
43
Quadratic phase errors
44
High-frequency phase errors
45
Autofocus – inverse filtering
46
Autofocus – inverse filtering
47
Autofocus – phase gradientThe phase gradient autofocus algorithm is unique in that it is not model based.
It estimates higher order phase errors as it accurately estimates multicycle phase errors in SAR signal data representing images over a wide variety of scenes.
48
Autofocus – phase gradient