50303652c hcg(i)-n4xxxv2s22eng.hitron.co.kr/wp-content/uploads/2016/07/hcgi... · 2017-04-27 ·...
TRANSCRIPT
PRODUCTION RELEASE & REVISION
REV DESCRIPT'N/BUYER DWG No PARTS No. BY CHK DATE
DRAWN
CHKED
2모조지100g/m WHITE
장경석 K.H.Jung
D.W.Hwang
50303652
50303652 11-12-M13
15-01-0915-01-09
HCG(I)-N4xxxV2S22/NoBrand
C
1051
48
(+/-
)5m
m
105(+/-5)mm x 148(+/-5)mm
M.J.KWON
15-01-09
15-01-09
700
3-AXIS VANDAL DOME CAMERA3-AXIS INFRARED-LED PLASTIC
DOME CAMERA
50303652 12-12-M13M.J.KWONB15-01-09D.W.HwangC 5030365215page Heater 내용추가
16p Demension 수정
rev.C - 15p Heater 내용추가 재고소진 후 적용
700
3-AXIS INFRARED-LEDVANDAL DOME CAMERA
3-AXISVANDAL DOME CAMERA
2
FCC INFORMATION :
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.
CAUTION : Changes or modifications not expressly approved by the party
responsible for compliance could void the user`s authority to operate the equipment.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numéique de la classe A est conforme à la norme NMB-003 du Canada.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and (2) (
this device must accept any interference received, including interference that may
cause undesired operation.
3
IMPORTANT SAFETY INSTRUCTIONS
1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that produce heat. 9. Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
10. Protect the power cord from being wa lked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer. 12. Use only with the cart, stand, tripod, bracket, or table specified by
the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid
injury from tip-over. 13. Unplug this apparatus during lightning storms or when unused for
long periods of time. 14. Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
15. CAUTION - THESE SERVICING IN STRUCTIONS ARE FOR USE BY QUALIFIED SERVICE PERSONNEL ONLY. TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT PERFORM ANY SERVICING OTHER THAN THAT CONTAINED IN THE OPERATING INSTRUCTIONS UNLESS YOU ARE QUALIFIED TO DO SO.
16. Use satisfy clause 2.5 of IEC60950-1/UL60950-1 or Certified/Listed Class 2 power source only.
4
IMPORTANT : The user of this camera is responsible for checking and complying with local, state, and federal laws and statues concerning the recording and monitoring of audio signals.
5 (IR Model 7Watts)
2.8 ~ 12mm Vari-focal lens or 3.6mmFixed lens for wide area monitering.
24V AC input / 12V DC inputpower source from a DC 12V or AC 24V ± 10% 60/50Hz ± 1HzUse Certified/Listed Class 2 power source only.
or 24V AC
5
3.6mm Fixed Lens
1. Make mounting holes and cable hole in the place (ceiling or wall) to which this dome camera is installed using the Drilling guide label.
2. Drill the mounting location, using the Drillng guide.
3. Attach the housing to the ceiling using suitable fasteners, PTS1 5x30 screws are supplied only use if they are suitable.
4. Tighten a mounting screws.
Press here to adjust the angle.
PTS1 5x30 <4X>
PT-Plug
6
7
8
9
10
11
12
13
14
IR
25M24
AC24V / DC 12V - 410mA(5.0Watts) - IR LED ON
515gWeightEtc.
f=2.8~12mm F1.2~360 Varifocal, ICR (D&N)f=3.6mm Fixed Lens
AC 24V / DC 12V - 200mA (2.5 Watts)
2-Pin Wire / Terminal Block / DC JackBNC Connector
700
1020(H) x 508(V) 1020(H) x 596(V)976(H) x 494(V) 976(H) x 582(V)
500g
Camera Control OSD (Joystic Switch)
Burst OFF / ON
IR LevelOFF / ONLow / High
Camera Title OFF / ONMotion Detec OFF / ON
Backlight OFF / BLC / HLC(High Light Compensation)
Lens Manual / DCShutter Auto, 1/60(1/50), Flickerless, 1/250 ~ 1/100,000sec
AGC OFF / LOW / MIDDLE / HIGHDWDR OFF / ONWhite Balance ATW1 / ATW2 / MANUAL / AWC->SET / ANTI. CRLDay & Night Auto / Color / B&W
Privacy Mask OFF / ONLens Shading OFF / ON(0 ~ 255)2DNR OFF / ONMirror OFF / ONFont Color Font 16 Color, ID&Title 16 ColorContrast 0 ~ 255Sharpness 0 ~ 31Display CRT / LCD / USERNega Image OFF / ONLanguage ENG / CHN( / GER / FR / JPN / RUS / PORT / SPTraditional, Simplified)
DPC Dead Pixel Cancellation (Auto 247 Points)Reset Not Save / Return
D&NB&W
SPECIAL
Ingress Protection IP 66
Day & Night System True ICR
Brightness 0 ~ 255
144(Φ) x 95(H) mm
DC 12V - 130mA (1.6 Watts)
DC 12V - 250mA(3.0Watts) - IR LED ON
*Heater Operating Temp. : 59°F(15°C)-ON / 77°F(25°C)-OFF ; tolerance ±5°C
Operating Temp. NormalHeater -22 -30
AC 24V / DC 12V - 530mA (7.0 Watts)DC 12V - 530mA (6.0 Watts)
(Heater)
AC24V / DC 12V - 840mA(10.0Watts) - IR LED ONDC 12V - 1000mA(12.0Watts) - IR LED ON
(Heater)
14
4
98
44
1.14 lb. (0.530kg)
1.44 lb. (0.650kg)
50303652C
1.8
95