8/2/2019 529495

1/4

TIP 0606-09OLD NUMBER 009-09

ISSUED 1964

REVISED 1973

REVISED 1981

REVISED 1986

REVISED 1992

REVISED 1997

REAFFIRMED 2002

2002 TAPPI

The information and data contained in this document wereprepared by a technical committee of the Association. The

committee and the Association assume no liability or responsibility

in connection with the use of such information or data, including

but not limited to any liability under patent, copyright, or tradesecret laws. The user is responsible for determining that this

document is the most recent edition published.

TIP Category: Data and Calculations

TAPPI

Dilution of caustic soda solutions

Scope

This Technical Information Paper presents information necessary for calculating how to dilute strong causticsoda solutions to produce a solution of the desired, lower concentration.

Safety precautions

Caustic soda is a highly corrosive material, which can cause severe burns to the eyes and skin. Eye contact ofonly a few seconds can cause permanent damage, even blindness. In all cases of bodily contact with caustic soda,

begin washing the exposed area immediately with large quantities of flowing water. The dilution of caustic soda is

a hazardous activity. Personnel engaged in the dilution of caustic soda should wear close-fitting chemical workers

goggles, rubber gloves, rubber apron or suit, and a face shield. When diluting caustic soda, always add caustic soda

to water with constant agitation. Never add water to caustic soda. Dilution water should be warm (27-38 degreesC), but neither hot nor cold. The addition of caustic soda to liquid will cause a rise in temperature. If caustic soda

becomes concentrated in one area, or is added too rapidly, or is added to hot or cold liquid, a rapid temperature

increase can result in dangerous mists or boiling and splattering which may cause an immediate violent eruption.

Dilution of caustic soda

Often it is necessary to calculate the amount of water or dilute caustic soda solution necessary for the dilution

of a strong caustic soda solution to a desired concentration. The following examples are provided to aid with

problems of this nature.

Dilution concentration are made by one of the following formulas:

V= [100H(A-B) ] / [R(B-C)]

or

W= [100(A-B)] / (B-C)

where

V= volume of weak liquor or water required per 100 volumes of original strong solution

W= weight of weak liquor or water required per 100 parts by weight of original strong solution

A = NaOH in original strong solution, %

8/2/2019 529495

2/4

TIP 0606-09 Dilution of caustic soda solutions / 2

B = NaOH desired in the diluted solution, %

C= NaOH in the diluting weak liquor, %

H= specific gravity of original strong solution

R = specific gravity of the diluting weak liquor

Sample calculation

Assume that it is desired to prepare a 23% NaOH solution from a stronger liquor of 49Be at 15.55C. From

appropriate concentration tables, it is found that a caustic soda liquor of 49Be corresponds to a 47.9% NaOH and a

specific gravity of 1.510 at 15.55C.

Substituting in formula 1:

V= [100 x 1.510 (47.9-23.0)] / [1.000 (23.0-0.0)]

V= 163.5 parts of water to be added to each 100 parts by volume of original strong solution

How to use the chart for diluting and mixing caustic soda solutions

Use of the chart on page 4 simplifies the calculation of problems such as:

1. How much water is needed to dilute a strong caustic soda solution to a weaker one?

2. How many gallons of strong solution are needed to bring a weak solution to a higher concentration?

3. What is the strength of a solution formed by mixing equal volumes of water and a caustic soda solution?

The left-hand line of the chart, zero percent, is of course water. The decreasing heights from left to right of

the vertical lines for percentage concentration reflect the greater weight per gallon of stronger solutions. The chart

does not take into consideration differences initial temperatures of solutions and water as well as volumetric changescaused by heat of dilution since these conditions usually have relatively small effects on final volume.

Problem 1

How many gallons of water should be added to dilute 1,000 gallons of 50 percent caustic soda solution to 19percent? (The latter concentration has the lowest freezing point and can withstand storage temperatures down to

approximately -18F.)

Solution:

Draw a line from zero percent on the weak solution scale at top to 50 percent on the strong solution scale atthe bottom. From the point where the drawn line intersects the 19 percent vertical line, read 70 gallons of weak

solution needed at right and 30 gallons of strong solution needed at the left.

Multiply the percentage ratio,

70 gallons weak solution

x 1,000 gallons strong solution = 2,333 gallons weak solution30 gallons strong solution

The answer is the number of gallons of water to be added.

8/2/2019 529495

3/4

3 / Dilution of caustic soda solutions TIP 0606-09

Problem 2:

How many gallons of 50 percent caustic soda solution should be added to 300 gallons of 10 percent solution

to obtain a final solution of 18 percent concentration?

Solution:

Draw a line from 10 percent on the weak solution scale at top to 50 percent on the strong solution scale at

bottom. From the point where the drawn line intersects the 18 percent vertical line, read 84 gallons of weak solution

needed at right and 16 gallons of strong solution needed at left.

Multiply the percentage ratio,

16 gallons strong solution

x 300 gallons weak solution = 57 gallons strong solution84 gallons weak solution

The answer is the number of gallons of 50 percent caustic soda solution to be added.

Problem 3:

What is the strength of the solution formed by mixing 10,000 gallons of 40 percent caustic soda solution with10,000 gallons of water?

Solution:

Draw a line from zero percent on the weak solution scale at top to 40 percent on the strong solution scale atbottom. The horizontal line connecting 50 on both left and right scales represents the 50:50 percentage ratio of the

10,000-gallon volumes stated in the problem. The drawn line intersects the horizontal ratio line at the 23 percent

vertical line, which is the concentration of the final solution.

Statement of Accuracy

These data were developed for a standard grade of caustic soda and will be satisfactory for nearly all

applications. There are several grades of caustic soda available commercially. If the application of this data is

intended for highly accurate calculations, the user should obtain specific data from the supplier of the product being

used.

Keywords

Dilution, Concentration, Chemical properties, Sodium hydroxide, Bleaching

Additional information

Effective date of issue: September 3, 2002

Working group members:

Dan Blevins Chairman, Dow Chemical

Phil Quinnett, Olin Chlor Alkali Products

David Fletcher, EKA Chemicals

8/2/2019 529495

4/4

TIP 0606-09 Dilution of caustic soda solutions / 4

g