hemodynamic monitoring part i (abp, cvp, ao)

Post on 31-Dec-2015

123 Views

Category:

Documents

1 Downloads

Preview:

Click to see full reader

DESCRIPTION

Hemodynamic Monitoring Part I (ABP, CVP, Ao). MICU Competencies 2006-2007. What is Hemodynamic Monitoring?. Non-invasive = clinical assessment & NBP Direct measurement of arterial pressure Invasive hemodynamic monitoring. Noninvasive BP Heart Rate, pulses Mental Status Mottling (absent). - PowerPoint PPT Presentation

TRANSCRIPT

1

Hemodynamic MonitoringPart I

(ABP, CVP, Ao)

MICU Competencies2006-2007

2

What is Hemodynamic Monitoring?

• Non-invasive = clinical assessment & NBP

• Direct measurement of arterial pressure

• Invasive hemodynamic monitoring

3

Noninvasive Hemodynamic Monitoring

• Noninvasive BP

• Heart Rate, pulses

• Mental Status

• Mottling (absent)

• Skin Temperature

• Capillary Refill

• Urine Output

4

Proper Fit of a Blood Pressure Cuff

• Width of bladder = 2/3 of upper arm

• Length of bladder encircles 80% arm

• Lower edge of cuff approximately 2.5 cm above the antecubital space

5

Why A Properly Fitting Cuff?

• Too small causes false-high reading

• Too LARGE causes false-low reading

6

Indications for Arterial Blood Pressure

• Frequent titration of vasoactive drips

• Unstable blood pressures

• Frequent ABGs or labs

• Unable to obtain Non-invasive BP

7

Supplies to Gather

• Arterial Catheter

• Pressure Tubing

• Pressure Cable

• Pressure Bag

• Flush – 500cc NS

8

Supplies to Gather

• Sterile Gown (2)

• Sterile Towels (3)

• Sterile Gloves

• Suture (silk 2.0)

• Chlorhexidine Swabs

• Mask

9

Leveling and Zeroing

• Leveling – Before/after insertion– If patient, bed or transducer move

• Zeroing – Performed before insertion & readings

• Level and zero at the insertion site

10

Potential Complications Associated With Arterial Lines

• Hemorrhage

• Air Emboli

• Infection

• Altered Skin Integrity

• Impaired Circulation

11

Documentation

• Insertion procedure note

• ABP readings as ordered

• Neurovascular checks every two hours(in musculoskeletal assessment of HED)

• Pressure line flush amounts (3ml/hr)

• Tubing and dressing changes

12

Central Venous Pressure Assesses . . .

• Intravascular volume status

• Right ventricular function

• Patient response to drugs &/or fluids

13

Central Venous Pressure (CVP)

• Central line or pulmonary artery catheter

• Normal values = 2 – 8 mm Hg

• Low CVP = hypovolemia or ↓ venous return

• High CVP = over hydration, ↑ venous return, or right-sided heart failure

14

Leveling and Zeroing

• Leveling – Before/after insertion– After patient, bed or transducer move– Aligns transducer with catheter tip

• Zeroing – Performed before insertion & readings

• Level and zero transducer at the phlebostatic axis

15

Phlebostatic Axis

• 4th intercostal space, mid-axillary line

• Level of the atria

(Edwards Lifesciences, n.d.)

16

More on Leveling and Zeroing

• HOB 0 – 60 degrees

• No lateral positioning

• Phlebostatic axis with any position (dotted line)

(Edwards Lifesciences, n.d.)

17

Dynamic Flush

Dynamic flush ensures the integrity of the pressure tubing system. Notice how it ascends - forms a square pattern - and bounces below the baseline before returning to the original waveform.•Check dynamic flush after zeroing any pressure tubing system

18

System Maintenance

• Change tubing and fluid bag q 96hrs

• No pressors through CVP port

• Antibiotics, NS boluses, blood, & IV pushes are allowed through the CVP line

19

Troubleshooting

• Improper set-up and equipment malfunction are the primary causes for hemodynamic monitoring problems

• Retracing the set-up process or tubing (patient to monitor) may identify the problem and solution quickly

• Use your staff resources: Help All, Charge Nurse, Educator, Preceptors, MICU experts

20

Troubleshooting

Damped Waveforms

Pressure bag inflated to 300 mmHg

Reposition extremity or patient

Verify appropriate scale

Flush or aspirate line

Check or replace module or cable

21

Troubleshooting

Inability to obtain/zero waveform

Connections between cable & monitor

Position of stopcocks

Retry zeroing after above adjustments

22

Continuous Airway Pressure (Ao)

• Also known as Paw, Ao

• Purpose:– Improves accuracy of hemodynamic

waveform measurements– Identification of end-expiration

• Positive waveform deflections = positive pressure ventilation

• Negative deflections = spontaneous inspiratory effort

23

Supplies to Gather

• Pressure Cable

• Pressure Tubing

• Connector

(Edwards Lifesciences, n.d.)

24

Setting up the Ao

• Discard infusion spike end & cap port

• Connect pressure tubing to vent tubing (using connector opposite heating cable)

• Connect cables • Zero the tubing (leveling not necessary)

25

Troubleshooting Ao

• Do not prime tubing with fluids!

• Damping will occur with fluid or secretions

• To evacuate any fluids, disconnect pressure tubing from vent tubing and push air through the pressure tubing with a 10 ml syringe connected at one end until fluid-free

26

1) Record Ao and CVP on the same strip2) Find end-expiration by drawing a vertical line with a

straight edge 200 ms prior to the rise or dip in Ao (1 large box) associated with a breath.

3) Draw a horizontal line through the visually assessed average vascular pressure starting at end-expiration going backward 200 ms (1 large box).

4) Read the pressure at the horizontal line.

Pressure Measurement

151510 10

5500

-5-5CVP=13 CVP=13

27

200 ms200 ms

Assist-ControlAssist-Control

AoAo

CVP CVP

{{

200 ms200 ms

{{

28

CPAP with Pressure SupportCPAP with Pressure Support

AoAo

CVPCVP

200 ms200 ms

{{

200 ms200 ms

{{

29

CPAP without Pressure SupportCPAP without Pressure Support

AoAo

CVPCVP

200 200 msms200 200 msms

{

200 ms200 ms

{{

30

403020100

-10

Incorrect method!This point was identified as end-expiration for a pt. who did not have an Ao set up.

Correct method!30 sec after the above tracing, Ao was added & true end-expiration clearly identified.

31

4040303020201010

00-10-10

Same patient 20 minutes later

4040303020201010

00-10-10

32

151510 10

5500

-5-5

CVP=13

33

Summary

•Record Ao with CVP

•Read mean CVP at end-expiration as described. No need read vascular pressure at any particular time in the cardiac cycle

34

Documentation of CVP

• Include on waveform strip – Position of the HOB– Vasopressors and rates– Amount of PEEP– Scale– CVP measurement– Signature of the nurse

(post in green chart behind graphics tab)

35

References & Resources

Burns, S. M. (2004). Continuous airway pressure monitoring. Critical Care Nurse, 24(6), 70-74.

Chulay, M., & Burns, S. M. (2006). AACN Essentials of critical care. McGraw-Hill: New York.

Edwards. (2006). Pulmonary Artery Catheter Educational Project. http://www.pacep.org

Edwards Lifesciences. (n.d.) Educational videos. www.edwards.com

MICU Routine Practice Guidelines. www.vanderbiltmicu.com

MICU Bedside Resource Books

MICU Education Kits (Red cart in conference room)

MICU Preceptors, Help All Nurses, & Charge Nurses

VUMC policies. http://vumcpolicies.mc.vanderbilt.edu

top related