inventor hsm 2015 help_ to tap the four holes (38)

11/10/2014 Help: To Tap the Four Holes

http://help.autodesk.com/view/INVHSM/2015/ENU/?guid=GUID-14419EA4-7144-4C27-B482-7B497A230DCE 1/4

Finish all machining operations by tapping the four holes.

1. On the ribbon, click CAM tab Drilling panel Drill .

Tool tab

1. Click the button to open the Tool Library.

2. From the CAM Mania Tutorial library, select #5 Ø0.138 x 0.03125" 0° right tap.

3. Click to close the Tool Library dialog.

Geometry tab1. On the Geometry tab, click the Hole faces button and select the face of one of the threaded holes.

2. Enable the Select same diameter check box. The other three remaining holes are automatically selected.

Cycle tab1. Click the Cycle tab.

2. Select Tapping from the Cycle type: drop-down menu.

Start the Calculation

1. Click the button, or right-click in the graphics window and select OK from the marking menu, to exit Drill and create thetoolpath.

Continue to To Simulate and Post Process the Toolpaths...

To Tap the Four Holes

SHARELIKE (0)

Continue to To Simulate and Post Process the Toolpaths...

Parent topic: CAM Mania Tutorial

Was this Article Helpful?

Please help us improve the content on this site. Was this article helpful? Yes No

Documents