kit 826-1950 includes: new sprocket new upper bracket new stickers new ground wires

Kit 826-1950 includes:

• New Sprocket

• New Upper Bracket

• New Stickers

• New Ground Wires

Toaster Speed Conversion Kit

• Remove cover.

• Remove compression knobs.

• Remove side panel.

• The bracket and the sprocket shown by arrows are changed with this kit.

• Ensure bolt securing large drive gear is positioned so it is accessible.

• Remove power from unit.

• Cut wire tie on diagonal brace and remove brace.

• Depress idler and lift chain from sprockets.

• If too tight, remove upper idler bracket to remove chain.

• Loosen bolt securing drive sprocket and use a straight-arm wheel puller to remove the sprocket.

• Remove upper idler bracket, remove sprocket from bracket and install on new bracket.

• The new drive sprocket, shown here on top of the older drive sprocket, is smaller and slows the toaster slightly. Install it in the same plane as the spring-loaded idler.

• Install the new ground wires and route from the ground position near the idler bracket to the higher ground position (shown above).

• Route the chain as shown and loop onto the upper idler before positioning the upper idler bracket on its mounting studs.

• Bolt the new upper idler bracket into place.

• Cut the provided bushings with wire dikes.

• Slip the cut bushing over an element wire...

• … and press it into place on the housing protecting the element ends.

• Replace diagonal brace and attach wiring with a wire tie, ensuring it stays out of the drive train.

• Apply the new crown and heel sticker to the bun guide.

• Replace the side and apply the new bun-compression sticker and replace the knobs.

• Attach the unit to power.

• Ensure proper operation.

• File all paperwork, being careful to include the serial numbers of the toasters modified and the store address.