team 3 prototype plans for team 5

Post on 07-Dec-2014

827 Views

Category:

Design

0 Downloads

Preview:

Click to see full reader

DESCRIPTION

Prototype instruction produced by Team 3 from Loughborough for the Team 3 in Vienna

TRANSCRIPT

Team Conker - AUSTRIAN CREATURES MASKNovember 2013

1 © James Green, Jagrut Mistry & Chris Sargent

1

2

34

5

6

7

8

The Austrian creatures mask is a culmination of the Perchta, Cuelebre and The Krampus. The mask is made from laser cut card with printed graphics.

There are two interchangeable features, the horns (7) and the tongue (8), both these parts have example graphics included. However the emphasis of a blank canvas should encourage a child’s creativity to create their own features.

The following pages lists the features numbered

Required:x3 A4 Card (at least 150gsm)x1 300mm length stringGlue Stick

7 8

DESCRIPTION

OVERVIEW

Team Conker - AUSTRIAN CREATURES MASK MASK GUIDE

String to be tied and placed here

November 2013

2 © James Green, Jagrut Mistry & Chris Sargent

1

2

3

5

6

4Brow

Left eye

Right eyeLeft frame

Right frame

Nose

HORN GUIDE

HORNSInterchangeable horns are included, within this is a set of x2 blank and patterned surfaces. These parts slot into the brow

slot into brow

Team Conker - AUSTRIAN CREATURES MASKNovember 2013

3 © James Green, Jagrut Mistry & Chris Sargent

7

1

Team Conker - AUSTRIAN CREATURES MASKNovember 2013

4 © James Green, Jagrut Mistry & Chris Sargent

TONGUE GUIDE

8 TONGUESInterchangeable tongues feature different shapes and colours. This also includes a blank template for customising. This attaches at two point through the nose 4

slots into nose

Team Conker - AUSTRIAN CREATURES MASKNovember 2013

5 © James Green, Jagrut Mistry & Chris Sargent

SCENARIO

Ideally the mask would be given away for free, where the end product is low cost and low tech but is effective in

promoting the various folklores

PROTOTYPE PLANS

The following pages are provided as .ai and .DXF files.The graphics should be printed first and then laser cut using

the .DXF file to create a ‘tear away’ feature for each part

6 © James Green, Jagrut Mistry & Chris Sargent

MASK NETTo assemble the mask cut along the solid linesFold along the dashed lines and connect each piece with glue

Cut out shapes or draw on the blank canvas to create your own mask!

Scale 1:1

HORN NETTo assemble the mask cut along the solid linesFold along the dashed lines and connect each piece with glue

The bottom flap connects to the mask

Scale 1:1

TONGUE NETTo assemble the mask cut along the solid linesFold along the dashed lines and connect each piece with glue

The top section connects into the slots in the nose to create a tongue and tusks

90° Fold

90° Fold

Scale 1:1

top related