asymmetrical gear analysis
TRANSCRIPT
GENBA SOPANRAO MOZE TRUST'S GENBA SOPANRAO MOZE COLLEGE OF ENGINEERING, BALEWADI
Seminar on“Stress Analysis of Eccentric Gear with
Asymmetrical Profile of Teeth”
Under guidance of,Prof. V.U.Mane sir
Presented by,Sachin YadagudiRoll No- 59
Objective
stress calculated in a standard way according to available formulas is approximate because some impacts cannot be determined with sufficient accuracy.
The problem is solved for elliptical, eccentric gear with asymmetrical profile of tooth.
Inroduction
• The stress calculation of this non-standard gearing is very complex
• Comparative stress• The complicated shape of the teeth is the
determination of stress in the teeth difficult• stress examining in a section of the foot tooth
with asymmetrical profile
Literature ReviewStress analysis of eccentric gear asymmetrical profil of teeth American journal of mechanical engineering volume-04 (Peter Frankovský)
geometric design of involute spur gear drives symmetric &asymmetric teethIternational Journal Of Mechanical Science (ognyan alipieve)
Bending Stress of Gearing
Gear with Asymmetrical Profile of Tooth
• Noncircular gear with variable transmission
• Module= 3.75 mm• Changing gear ratio for
analysis • Ellipse formed with the
basic parameters
Meshing of Gears
Analysis of Gears
• Mesh generated elliptical gear, speed varies in u=0.5 through u=1.0 until u=2.0 and back
• Drive wheel gear speed is constant
• Continuous changing of the gear ratio driven wheel speed is not constant