Frequency adjustment:First, manually adjustThe FR button switches the frequency.Short press: switch channels, 4 blue LEDs indicate channels.Long press (2 seconds): switch group, 3 green LEDs indicate the group.There are 48 frequency points, and the specific channel frequency reference frequency list.

Power switch:POW button Power adjustment. Press once to switch power 25MW, 100MW, 200MW, 400MW, 600MWThe default shipment is 600MW.

OSD adjustment method:    In the flight control PORTS, you need to configure the TX3 to be used for the OSD adjustment parameters (the internal circuit will connect the OSD adjustment interface and the TX3 of the flight control). In the UART3 in the figure below, select the IRC Tramp.

The first stepCorrectly configure the receiver to ensure that each channel of the receiver is normal. For example, the OSD is TX3, the receiver is DSM/IBUS is RX1, and SBUS is RX6.Second stepPut the throttle at about 50% of the neutral position (THR MID), turn the direction lever to the leftmost (YAW LEFT), and push the pitch lever up (PITCH UP). Enter OSD menuThird step Switch VTX channel and transmit power,On the MAIN page, select the FEATURES item and go to the FEATURES page.Select the VTX TR option to enter the VTX pageSelect CHANNEL switch channel, select POWER switch transmit power,Select SET, select YES, the setting takes effect.

Receiver configuration:1, PPM receiver configuration

2、SBUS receiver

3、 DSM/IBUS receiver

DSM:

IBUS: