brother xr-40 lightbulb replacement guides/brother xr-40 lightbulb... · to reassemble your device,...
TRANSCRIPT
Brother XR-40 Lightbulb ReplacementThis guide will demonstrate how to replace the lightbulb in the Brother XR-40 sewing machine.
Written By: Kevin Bickers
Brother XR-40 Lightbulb Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 7
INTRODUCTION
Replacing the lightbulb involves opening up the machine. You will need to purchase a sewingmachine bulb set, including the wire plug-in, to replace it.
TOOLS:Phillips #2 Screwdriver (1)
Utility Scissors (1)
Flathead Screwdriver (1)
PARTS:Zip Ties (1)
Brother XR-40 Lightbulb Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 7
Step 1 — Back Panel
Place the machine on a solidsurface.
Remove the 14mm Phillips #2 screwholding on the face cover.
Step 2
Remove the two 14mm Phillips #2screws and two 22mm Phillips #2screws that secure the rear casing.
Brother XR-40 Lightbulb Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 7
Step 3
Lay the machine on its side.
Remove the four 10mm Phillips #2screws that hold the bottom panel inplace.
The feet will come off with thescrews.
Step 4
Remove the bottom panel.
Brother XR-40 Lightbulb Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 7
Step 5
Place the machine upright.
Remove the rear casing.
You may have to wiggle the paneland pull at the same time.
Step 6 — Lightbulb
Using scissors, clip the two zip tiessecuring the lightbulb wire.
Brother XR-40 Lightbulb Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 7
Step 7
Place the machine on its side, withaccess to the bottom.
Gently pull out the white wireconnecting the bulb to the machine.
Step 8
Move the wire out from under theplastic hook.
Brother XR-40 Lightbulb Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 7
To reassemble your device, follow these instructions in reverse order.
This document was last generated on 2017-07-02 05:46:01 AM.
Step 9
Place the machine upright.
Using the flathead screwdriver,remove the 5mm Flathead screwholding on the lightbulb bracket.
Step 10
Remove the lightbulb assembly.
Brother XR-40 Lightbulb Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 7