bullseye - samtec microelectronicssuddendocs.samtec.com/ebrochures/bullseye_flyer_40_ghz.pdfbulls...
TRANSCRIPT
samtec.com/BullsEye
40 GHz, Gen 2 Bulls Eye® AssembliesPogo-pin for signal and ground
Compression interface design, small footprint and high-cycle count make Bulls Eye® ideal for high-performance test applications.
• High-density array test point– Double-row (BE40A)
• Advanced Cable solutions– 23 AWG, solid dielectric – Low-loss microwave – Copper foil shield
• Microstrip or Stripline PCB Transmission
• Replacement components (cable and block)
• 50 Ω impedance
• Phase-matched pairs
• End 2: 2.92
• Cable management available with protective sleeve
• Test boards available for performance verification, contact [email protected]
Backward compatible with BDRA Gen 1 Microstrip Stripline Pogo-pin design for
both signal and ground
BE40A
Signal GroundBE40A Compression interface to the board
samtec.com/BullsEye
Assemblies to 40 GHzUp to 65 GHz in development
Cable Type 23 AWG Quad Row
20 (Quad Row)
2.92 mm Jack / Plug
2x12
2.92 mm Jack / Plug 2.4 & 1.85 mm(TBD)
Stripline
Elastomer
Microstrip or Stripline
Pogo-pin design on Bulls Eye® probe end
2x3, 2x4, 2x6, 2x8, 2x10, 2x12, 2x14, 2x16
23 AWG Double Row 23 AWG Double Row,Copper Foil Shield
PCB Transmission
Ground
No. of Positions
End 2 Options
20 GHz, Gen 1 40 GHz, Gen 2 Up to 65 GHzin Development
BQRA Series BDRA Series BE40A Series TBD
TBD
InstallationThere are a variety of series within the Bulls Eye® family, and while the attachment process is similar, each have unique specifications that need to be observed. For questions, please contact: [email protected]
RF Technical [email protected]
Signal Integrity [email protected]
Dedicated RF engineers and Signal Integrity experts provide personal support for meeting your specific challenges.
Launch Optimizations • Simulations • Test & Measurements • Customs
In Development
* Replacement components available (cables, blocks, elastomer). Contact Samtec.