configuration of securew2 software for network connection on vista and windows7

8/2/2019 Configuration of SecureW2 Software for Network Connection on Vista and Windows7

1/15

1

Configuration ofSecureW2 software for Network connection on Windows 7 and Windows Vis

Right Click on Network, then click on Properties.

Or, click on the Network Icon at the bottom and click on Open Network and Sharing

Center.

STEP 1 Configuring Your Desktop/Laptop for Network Connection


2/15

2

Once the Network and Sharing Center opens click on Manage network connections

(In VISTA) or Change adapter settings (In Windows7).


3/15

3

Right click on wireless network connection, then click on Properties.

Click on Internet Protocol Version 4 (TCP/IPv4), Then click on Properties


4/15

4

Check the components Obtain an IP address automatically & Obtain DNS

server address automatically, Then click Ok.

Again open the Network and Sharing Center and click on Manage wireless

networks.


5/15

5

Right Click on the available wireless networks and click on Properties.

Note: - If wireless network not showing in the list then continue otherwise

goto page 7.

1. Click on the Add button at the top and click Manually create a network profile.


6/15

6

Type the Network name exactly as it appears in the list of available Connections in your laptop/desktop.

[Refer the two pictures below. Spaces, upper and lower cases should be taken care of.]

Select Security type: WPA2-Enterprise, Encryption type: TKIP, and uncheck

Start this connection automatically and press Next.

Wireless network will be added successfully. Click on Change connection

settings to customize further.


7/15

7

Click on Connect even if the network is not broadcasting its name (SSID)

and then click on the Security tab.

On the Security tab, select SecureW2 EAP-TTLS from the Choose a network

authentication method: drop down box then click on Settings button.


8/15

8

Click on configure button ofSecureW2 Configuration window.

Click on Connection Tabuncheck the Use alternate outer identity:


9/15

9

Click on Certificates Tab Uncheck the Verify server certificates

Click on Authentication Tab, Then from Select Authentication Method: drop

down menu, select PAP.


10/15

10

Click on User account Tab, then check the components Prompt user for

credentials.Click on Advanced button.

Check the components Allow users to setup new connections.

Click on OK.


11/15

11

Click on OK.

Click on OK.


12/15

12

Click on OK and close all other windows.

Again click on the Network Icon at the bottom and click on Connect to a

network.


13/15

13

Click the available network and click the Connect button.

When you click on Connect button a window appears [In Windows7] for you where

you are needed to put your cyberoam/NITRKL mailuser name & password-> then

click ok. For Vista proceed to next page.

NOTE- Domain not required


14/15

14

Note: -In Vistaafter you click the connect button, a Connect to a network window

appears. Here, you click on Enter/select additional logon informationto get the

SecureW2 Credentials [refer the picture above] window where you will put your

cyberoam/NITRKL mailuser name & password -> then click ok.

You are now successfully connected to your access point. Click the close button.


15/15

15

Choose location for your Access point as Work network.

The network location is now set.

*****************

configuration of securew2 software for network connection on vista and windows7

Documents