Download - Creating a simple motor. open office only
PrePared by: Melchor cariñob.S.i.T(icT)
iTfndS1 Thu 11:30 – 2:00
creaTing a SiMPle MoTorcreaTing a SiMPle MoTor
creaTing a SiMPle MoTor iS juST SiMPle.
brief deScriPTionbrief deScriPTion
MaTerialSMaTerialS
● Battery
● Thumb Tacks
● Insulated Copper
● Wood
● Two 3 and 1/2 inch nails
● Paper Clip
● Knife, Cutter, or Scissor
● Electrical Tape
● Long-Nose Plier
STeP 1STeP 1
Bend each clip using the long-nose Pliers
Get two of the clips
This is the Process
STeP2STeP2Place the first clipPlace 2 thumb tacksPlace the second clip with a distance of 1 inch
STeP 3STeP 3Get the third clipBend both ends Perpendicularly
Use the insulated copper to wind the clip tightly
20 turns
20 turns
Wrap the electrical tape on both ends as shown belowUse the knife or cutter to
remove the insulator Cut both ends of the copper
STeP 4STeP 4Get the two Nails
Wrap each nail with wire leaving about 9 inch of wire
Wrap each nail leaving 6 inch going up to the middle
Remove the Insulator using knife or cutter
STeP 5STeP 5Put the rotor clipGet the two electromagnet nails
and put it beside the arrow shown below
Hammer it down
STeP 6STeP 6Put the wire that will be
connected to the rotor clip Put thumb tacks on it Connect A and B
D
A
BC
-
+
Connect C and DThe 2 connections that are left will serve as + and – for the
battery
ouTcoMeouTcoMe