Download - IPSM-1C40 IPSM-1C40M datasheet en eu v1
EDUCATIONAL, CORRECTIONAL IP INTERCOMMESSAGING, PAGING SYSTEM
CONTROL & FEATURES
Support PoE+ and/or connect to 24VDC power adapter (if PoE+ is not
available)
Standard RJ45 interface, PCB control and Class-D amp board
Cost e�ective and simple installation with single cable deployment
Easily con�gured, controlled, managed and monitored via web browser
Full DSP system with superior audio quality
Microphone input built-in for hands-free duplex intercom(IPSM-1C40M)
IP based for music streaming, routing, paging and control over LAN/WAN
Paging with priority management, event management and general fault reports
3rd party control integration with TERRACOM system and IP-PBX via SIP protocol
Support to connect to TERRACOM system for I/O expansion
Support audio codec G.711, G.722, WAV and MP3
3 control inputs, 1 contact output , clock module interface and USB
interface (function reserved)
OVERVIEWThe IPSM-1C40/IPSM-1C40M module is equipped with 1 channel 40W Class-D amp board into the 4 ohm or 8 ohm loudspeaker with PoE+ power(and/or 24VDC power supply if POE+ is not available). With Power over Ethernet(PoE+) technology, both audio control and power can be �owed over the standard female RJ45 Ethernet connector, giving a cost e�ective way to used as the SIP endpoint of paging, intercom, mass noti�cation system and minimizing the number of cables. The IPSM-1C40M module also comes with a microphone input built-in, allowing for hands-free intercom.The PSM-1C40/IPSM-1C40M has 3 control inputs for level control using RAC remote device, 1 contact output for triggering events via TerraManager and a clock module interface for connecting to time clock display. To con�gure, control, monitor the IP speakers in real-time, this can be easily done through your favorite web browser interface which makes the management even the most complex environments simpler than ever. The remarkable features include priority management, event management, volume control, AEC(Acoustic echo cancellation), NR (Noise Reduction), paging, intercom, music streaming, routing, logic control, monitoring etc..
IPSM-1C40 - IP SPEAKER MODULE, 1 CHANNEL, 40WIPSM-1C40M - IP SPEAKER MODULE, 1 CHANNEL, 40W WITH MICROPHONE INPUT BUILT-IN
FRONT PANEL1. 24VDC power input (+ - )2. RJ45 Ethernet connector3. 1 channel, 40W amp output (+ - )
REAR PANEL1. 3 logic control inputs2. 1 contact output3. Microphone input (IPSM-1C40M only)4. USB interface (function reserved)
SIDE PANEL1. LED strobe connector(- +)2. Clock module interface 3. Power LED (+ -)4. Status LED (+ -)
3 41 2
23
EthernetPOE+
DCPowerAMP1
1 2341 2 3 C
www.pentonuk.co.uk
EDUCATIONAL, CORRECTIONAL IP INTERCOMMESSAGING, PAGING SYSTEM
SPECIFICATIONS
Power over Ethernet(POE+), IEEE802.3af, class 3
24 VDC power transformer(18~24VDC), minimum power supply: 2A
Type Euro-block
Mode(analog/TTL) max. 3.3 VDC
TTL logic input (max.) HIGH active 3.3 VDC, LOW active 1.2 VDC
ELECTRICAL
Type
Frequency response
Max. power output
THD+N@20W/40W
1 channel, 40W Class-D ampli�er
±3 dB @ 50 Hz ~ 20 kHz
40 watts
Phantom power 2 VDC
1 %(50 ~ 20 kHz@ full power)
Frequency response ±1 dB @ 50 Hz~20 kHz
SNR 85 dBu @ 50 Hz~20 kHz @ 4Ω
Input impedance(unbalanced) 1K ohm
EIN (Equivalent Input Noise) -90 dBu @ 14 dBu gain
THD+N 0.1 %(50~20 kHz @ 14 dBu gain)
Ampli�ed Output Mic Input
AUDIO CHARACTERISTICS
CONTROL INPUTS
Dimensions(W x L x H) 3.8 x 1.37 x 2.75 inch(9.8 x 3.5 x 7 cm)
Net weight 0.66 lbs(0.3 kg)
Operating temperature
Storage temperature
23ºF~131ºF(-5ºC~55ºC)
-40 ºF~158 ºF(-40 ºC~70 ºC)
Relative humidity 0 % to 70 %
Air pressure 600 to 1100 hPa
Heat dissipation 6.82 BTU/hr
MECHANICAL & ENVIRONMENTAL
IPSM-1C40 IP Speaker Module/1 channel/40W
IPSM-1C40M IP Speaker Module/1 channel/40W w/mic
ORDERING INFORMATION
Audio compression G.711, G.722, Wav, MP3
AUDIO
10/100 Mbps Base TX Ethernet RJ45
NETWORKING
Type Euro-block
Default status OPEN(N.O.)
Voltage 100 VDC(max.)
Current 0.5A(max.)
CONTACT OUTPUT
Female RJ45 socket, CAT-5/CAT-6 cables
Max. cable length 100M
INTERCONNECTION
Manual or Dynamic Host Con�guration Protocol(DHCP) IP address setup
Time and date synchronization using NTP
SIP 2.0(peer and proxy)
IETF SIP(RFC3261)
IETF IGMP version 2(RFC2236)
IETF RTP(RFC1889)
SUPPORTED PROTOCOLS
CE/EMI EN 55013/CISPR13
CE/EMS EN 61000-4-2(ESD)
SAFETY(CERTIFIED PENDING)
IPSM-1C40 - IP SPEAKER MODULE, 1 CHANNEL, 40WIPSM-1C40M - IP SPEAKER MODULE, 1 CHANNEL, 40W WITH MICROPHONE INPUT BUILT-IN
*NOTICE (MICROPHONE CAPSULE)
We recommend to use a temperature controlled soldering iron (360 degree) and the welding time must less than 3 seconds to keep contact of the iron to the microphone capsule as brief as possible.
Penton UK LtdUnit 2 Teville Industrials | Dominion Way | Worthing | West Sussex | BN14 8NW
T: +44 (0)1903 215315 | F: +44(0)1903 215415 | E: [email protected]
www.pentonuk.co.ukRoHS
www.pentonuk.co.uk
Manufacturer reserves the right to alter specifications without notice