EDUCATIONAL, CORRECTIONAL IP INTERCOMMESSAGING, PAGING SYSTEM

CONTROL & FEATURES

Support PoE+ and/or connect to 24VDC power adapter (if PoE+ is not

available)

Standard RJ45 interface, PCB control and Class-D amp board

Cost e�ective and simple installation with single cable deployment

Easily con�gured, controlled, managed and monitored via web browser

Full DSP system with superior audio quality

Microphone input built-in for hands-free duplex intercom(IPSM-1C40M)

IP based for music streaming, routing, paging and control over LAN/WAN

Paging with priority management, event management and general fault reports

3rd party control integration with TERRACOM system and IP-PBX via SIP protocol

Support to connect to TERRACOM system for I/O expansion

Support audio codec G.711, G.722, WAV and MP3

3 control inputs, 1 contact output , clock module interface and USB

interface (function reserved)

OVERVIEWThe IPSM-1C40/IPSM-1C40M module is equipped with 1 channel 40W Class-D amp board into the 4 ohm or 8 ohm loudspeaker with PoE+ power(and/or 24VDC power supply if POE+ is not available). With Power over Ethernet(PoE+) technology, both audio control and power can be �owed over the standard female RJ45 Ethernet connector, giving a cost e�ective way to used as the SIP endpoint of paging, intercom, mass noti�cation system and minimizing the number of cables. The IPSM-1C40M module also comes with a microphone input built-in, allowing for hands-free intercom.The PSM-1C40/IPSM-1C40M has 3 control inputs for level control using RAC remote device, 1 contact output for triggering events via TerraManager and a clock module interface for connecting to time clock display. To con�gure, control, monitor the IP speakers in real-time, this can be easily done through your favorite web browser interface which makes the management even the most complex environments simpler than ever. The remarkable features include priority management, event management, volume control, AEC(Acoustic echo cancellation), NR (Noise Reduction), paging, intercom, music streaming, routing, logic control, monitoring etc..

IPSM-1C40 - IP SPEAKER MODULE, 1 CHANNEL, 40WIPSM-1C40M - IP SPEAKER MODULE, 1 CHANNEL, 40W WITH MICROPHONE INPUT BUILT-IN

FRONT PANEL1. 24VDC power input (+ - )2. RJ45 Ethernet connector3. 1 channel, 40W amp output (+ - )

REAR PANEL1. 3 logic control inputs2. 1 contact output3. Microphone input (IPSM-1C40M only)4. USB interface (function reserved)

SIDE PANEL1. LED strobe connector(- +)2. Clock module interface 3. Power LED (+ -)4. Status LED (+ -)

3 41 2

23

EthernetPOE+

DCPowerAMP1

1 2341 2 3 C

www.pentonuk.co.uk

EDUCATIONAL, CORRECTIONAL IP INTERCOMMESSAGING, PAGING SYSTEM

SPECIFICATIONS

Power over Ethernet(POE+), IEEE802.3af, class 3

24 VDC power transformer(18~24VDC), minimum power supply: 2A

Type Euro-block

Mode(analog/TTL) max. 3.3 VDC

TTL logic input (max.) HIGH active 3.3 VDC, LOW active 1.2 VDC

ELECTRICAL

Type

Frequency response

Max. power output

THD+N@20W/40W

1 channel, 40W Class-D ampli�er

±3 dB @ 50 Hz ~ 20 kHz

40 watts

Phantom power 2 VDC

1 %(50 ~ 20 kHz@ full power)

Frequency response ±1 dB @ 50 Hz~20 kHz

SNR 85 dBu @ 50 Hz~20 kHz @ 4Ω

Input impedance(unbalanced) 1K ohm

EIN (Equivalent Input Noise) -90 dBu @ 14 dBu gain

THD+N 0.1 %(50~20 kHz @ 14 dBu gain)

Ampli�ed Output Mic Input

AUDIO CHARACTERISTICS

CONTROL INPUTS

Dimensions(W x L x H) 3.8 x 1.37 x 2.75 inch(9.8 x 3.5 x 7 cm)

Net weight 0.66 lbs(0.3 kg)

Operating temperature

Storage temperature

23ºF~131ºF(-5ºC~55ºC)

-40 ºF~158 ºF(-40 ºC~70 ºC)

Relative humidity 0 % to 70 %

Air pressure 600 to 1100 hPa

Heat dissipation 6.82 BTU/hr

MECHANICAL & ENVIRONMENTAL

IPSM-1C40 IP Speaker Module/1 channel/40W

IPSM-1C40M IP Speaker Module/1 channel/40W w/mic

ORDERING INFORMATION

Audio compression G.711, G.722, Wav, MP3

AUDIO

10/100 Mbps Base TX Ethernet RJ45

NETWORKING

Type Euro-block

Default status OPEN(N.O.)

Voltage 100 VDC(max.)

Current 0.5A(max.)

CONTACT OUTPUT

Female RJ45 socket, CAT-5/CAT-6 cables

Max. cable length 100M

INTERCONNECTION

Manual or Dynamic Host Con�guration Protocol(DHCP) IP address setup

Time and date synchronization using NTP

SIP 2.0(peer and proxy)

IETF SIP(RFC3261)

IETF IGMP version 2(RFC2236)

IETF RTP(RFC1889)

SUPPORTED PROTOCOLS

CE/EMI EN 55013/CISPR13

CE/EMS EN 61000-4-2(ESD)

SAFETY(CERTIFIED PENDING)

IPSM-1C40 - IP SPEAKER MODULE, 1 CHANNEL, 40WIPSM-1C40M - IP SPEAKER MODULE, 1 CHANNEL, 40W WITH MICROPHONE INPUT BUILT-IN

*NOTICE (MICROPHONE CAPSULE)

We recommend to use a temperature controlled soldering iron (360 degree) and the welding time must less than 3 seconds to keep contact of the iron to the microphone capsule as brief as possible.

Penton UK LtdUnit 2 Teville Industrials | Dominion Way | Worthing | West Sussex | BN14 8NW

T: +44 (0)1903 215315 | F: +44(0)1903 215415 | E: SALES@PENTONUK.CO.UK

www.pentonuk.co.ukRoHS

www.pentonuk.co.uk

Manufacturer reserves the right to alter specifications without notice