important safety...
TRANSCRIPT
- 1 -
◎Important Safety Precautions
Read all instructions before operating this device.
Clean seven sensors and side brush before using.
Water only. Do not add any detergent into water tank.
Put cleaning cloth onto the device flatly before using.
Avoid using the device on greasy ground.
Do not use the device in areas containing flammable or combustible liquids
or gases.
Avoid exposing the device to direct sunlight or excess humidity and keep it
away from liquids.
Keep electrical leads, hair and curtains away from the device.
The device can only be used indoor.
◎General Safety Information
Follow all operating and use instructions.
Do not place the device in the vicinity of strong magnetic fields.
Keep the device and accessories away from children.
Product operating temperatures: 0°C ~40°C (32°F ~104°F)
Product storage temperatures: -10°C ~50°C (14°F ~122°F)
The device can be used by children aged from 8 and above and
persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given
supervision or instruction concerning use of the device in a safe way
and understand the hazards involved. Children shall not play with
the device. Cleaning and user maintenance shall not be made by
children without supervision.
Warning:
Do not expose the electronics of LEGEE, or the integrated. There are
no user service able parts inside. Refer servicing to qualified service
personnel. Please ensure electrical input voltage is compatible with
the charging station.
- 2 -
◎Safety information about power adapter/battery
Use only the power adapter supplied with the device. Use other types of
power adapters will result in malfunction and/or danger.
Please use a proper electrical outlet and make sure no heavy objects are
placed on the power adapter or the power cord.
Disconnect the power before maintaining, unplug the transformer from the
socket. Do not use a broken adapter and power cord.
Allow adequate ventilation around the adapter when using it to operate the
device. Do not cover the power adapter with objects.
Do not use the adapter in a humid environment. Never handle the adapter
with wet hands.
Do not attempt to service the adapter. There are no service parts included.
Replace the whole unit if it is damaged or exposed to high moisture. Consult
your HOBOT dealer for help and maintenance.
The battery used in this device may present a risk of fire or chemical burn if
mistreated.
Do not disassemble, short the contacts, heat above 60°C (140°F), or
incinerate.
If you have to dispose of old equipment, please take it to the local recycling
center for recycling electrical and electronic parts.
Please charge the battery every 3 months to conserve the battery life.
◎Not covered by warranty
Normal wear and tear (e.g. side brush, cleaning cloth, nozzle, caterpillar belt
and filter, etc.)
Reduction in battery discharge time due to battery age or use. (Battery life:1
year)
Damage caused by assembly or installation that is not in accordance with
the instructions included with the LEGEE.
Damage caused by using the LEGEE for anything other than normal
domestic household purposes.
Damage caused by using parts and accessories which are not specified by
LEGEE.
Damage caused by accidents, abuse, or misuse.
- 3 -
◎Copyright
Copyright © 2017 by HOBOT® Technology Inc. All rights reserved. No part of this
publication may be reproduced, transmitted, transcribed, stored in a retrieval
system or translated into any language or computer language, in any form or by
any means, electronic, mechanical, magnetic, optical, chemical, manual or
otherwise, without the prior written permission of this company.
◎Trademarks
All other logos, products, or company names mentioned in this manual may be
the registered trademarks or copyrights of their respective companies, and are
used for informational purposes only.
◎Technical support
If any problems occur and this manual cannot provide the solution you need,
please contact a local retailer or local authorized dealer.
◎Disclaimer
HOBOT Technology Inc. makes no claims or warranties, either expressed or
implied, with respect to the contents hereof and specifically disclaims any
warranties, tradability or suitability for any particular purpose. Furthermore,
HOBOT Technology Inc. reserves the right to revise this publication and to make
changes from time to time in the contents hereof without obligation of this
company to provide notification of such revisions or changes.
The user should follow the instructions provided in this user manual, but is
ultimately responsible for assessing placement and safety when using this
cleaning tool.
◎Limited warranty
If there are defects in your LEGEE due to faulty materials, poor workmanship, or
malfunction within the warranty period from the date of purchase or delivery,
please contact a local retailer or local authorized dealer for repairs or
replacement.
- 4 -
◎About LEGEE
- 5 -
◎Specifications
Model No LEGEE-668
Cleaning Method FastBrush 4-Stage Cleaning
Brush speed 10 times/sec
Navigation Technology LEGEE® V1.0
Path Map, Parallel
Moving Speed 20cm/sec (8 inch/sec)
Water control Pump Control, Smart Spray
Side brush Stretched out 4 cm (1,5 inch) from device
Trash capacity 500 ml
Trash filter 600# Screen Filter + HEPA
Water tank 320 ml
Battery Li-Po 3000mAh
Working time 90 minutes
Cleaning area per charge 150 meter2 (1600 feet2)
Object detection 5 Lasers + Bumper
Cliff sensor 2 Lasers
Charge Charging Station
Noise Level 62dB at 1m (3,3 inch)
Dimension (LWH) 340 x 330 x 95 mm (13,4 x 13 x 3,7 inch)
Input Voltage 100 ~240V, 50~60Hz
Adapter Output 19V / 1A, 19W
Color Black
Weight 3.2 Kg (7 lbs)
◎Cleaning cloth laundry instructions
Washing under 40°C (104°F).
Do not bleach.
Do not tumble-dry.
Do not iron.
Do not dry clean.
- 6 -
◎Product and Accessories
LEGEE
Charging station
AC adapter
Remote controller
Cleaning cloth(2 x 2 sets)
Spray nozzles (x4)
Water bottle
Side brush(x3)
HEPA (x3)
Cleaning brush
User manual
- 7 -
◎Product Features
Exclusive patent license: FastBrush 4-Stage Cleaning
Fastbrush 4-stage cleaning means all-in vacuum, dry mopping, self-watering
and wet mopping. The power vacuum can suck dust and hair and the
reciprocating cleaning mechanism at 10 times/sec imitates the human behavior
to remove the stubborn dust off the floor. The smart self-watering is as the third
stage to dissolve stains, which cannot be vacuumed or cleaned dryly. The rear
cleaning cloth not only wipes water and clean the melted stains but also polishes
the floor.
Exclusive patent license: LEGEE® Smart Navigation Technology
LEGEE-668 uses Laser,
Encoder, Gyro, E-compass
and Position Estimation to
detect and measure the
space around it. LEGEE is
an advanced navigation
system that allows it to
avoid furniture and other
objects. It also can precisely
plan the cleaning path to
clean an entire level of your
home.
- 8 -
◎Getting to know the device
1. Start your LEGEE
Step 1.Set up charging station: Plug power adapter into the charging station.
Step 2.Charge LEGEE: Place the rear of the robot against the metal contacts on
the station. Before the first use, fully charge the battery for at least 4
hours until green light ON.
Step 3.Start cleaning: Open the cover of LEGEE and push down the power
switch, then close the cover of LEGEE and press on the device or
the remote controller. (Make the device face a flat wall if it doesn’t clean
from the charging station.)
Step 4.Stop cleaning: Press Stop on the remote controller.
- 9 -
2. Install Charging Station
Step 1.
Place the charging station against a wall on
hard surface flooring to prevent sliding during
docking.
Step 2.
Ensure that there no objects at least 1.5
meter (5 feet) in front and 1.5 meter (5 feet)
to the right and left of the charging station.
3. Attach / Change Cleaning Cloth
Attach the cleaning cloth to the device flatly. (as indicated by the red line in the
illustration below)
4. Fill water
Fill LEGEE with water by using the included bottle and tighten the lid of the water
tank after filling.
5. Cleaning Tips
Get the front cleaning cloth wet before attaching to the LEGEE to enhance the
cleaning ability, it particularly cleans large area or stubborn stains.
1.5 M 1.5 M
1.5 M
- 10 -
◎Remote Controller
◎LED Indication
Situation LED Indication
Dry mopping Solid
Wet mopping Solid
Spraying water Flashing
Low battery Flashing
Searching charging station Flashing
Battery charging Solid
Battery charged full Solid
Warning Flashing
Fault state Flashing
- 11 -
◎Cleaning & Maintainance
1. Clean 7 laser sensors
Press the right side of the bumper and then pull the left side of the bumper
out to remove a front bumper.
Use a clean, dry soft cloth or the cleaning brush to clean 7 laser sensors. (as
indicated in the illustration below)
Care Frequency: Before each use.
2. Clean dust box & HEPA filter
Open bin door to empty bin.
To use the cleaning brush to clean the HEPA. Never wash the HEPA.
Care Frequency: After each use.
- 12 -
3. Clean & replacement side brush
Clean side brush and reinstall it.
Replace side brush and click it into place to make sure it is locked.
Care Frequency: After each use.
4. Clean & replacement spray nozzles
Use small screwdriver to remove the screw and nozzle.
Clean / remove the nozzle and screw it back.
Care Frequency: When nozzle clogged and cannot spray water.
- 13 -
◎Frequently asked questions (FAQ)
Case Solution
1. Cannot be turned on Check power is on and the battery has been charged.
2. Cannot be charged
Check power is on and the power supply is
connected to the charging station. Remove objects
around the home station or use cleaning brush to
clean the 7 sensors. (Page 11)
3. Poor contact with
charge contacts
Use a clean cloth or alcohol to wipe charge contacts
to remove oxide.
4. Abnormal sound Turn off power then check if any foreign material
stuck in the side-brush.
5. Cleaning ability
becomes weak
Turn off power then clean side-brush, dust box, HEPA
and cleaning cloth.
6. Movements or clean
path are abnormal
Turn off power then clean 7 sensors and check if the
bumper is properly installed.
7. The side brush does
not rotate
Turn off power then check if any foreign material
stuck in the machine. Clean the side brush and
confirm it has been mounted properly.
8. Nozzle cannot spray
water
Turn off power then check if the nozzle is clogged or
if it’s locked on the LEGEE properly.
9. Test water spray
Press the STOP button then press 3 times in 1.5
seconds to enter the water test mode. LEGEE will
spray water every 5 seconds.
10.Spray too much water Press to stop the water.
11.The height of carpet When LEGEE crosses the carpet more than 3mm, it
can be regarded as obstacles and vice versa.
12.Cannot be activated
with remote control
Check power is on and replace the batteries of the
remote control. Point the remote control at LEGEE.
13.Make LEGEE work
efficiently
Remove carpet, cable, wire and small objects from
the floor and lift up the table cloths and curtains.
- 14 -
◎HOBOT Customer Service in the US
Home Robot LLC provides limited warranty, service, and repair of our products. We
also supply accessories and parts for all HOBOT models.
217 Miracle Strip Pkwy
Fort Walton Beach, FL 32548
1.833.462.6887. Monday through Friday, 9am-5pm EST.
www.homerobotusa.com
◎WARRANTY CARD
The warranty for LEGEE-668 is 12 months from the date of purchase.
The warranty for the battery is 6 months from the date of purchase.
The service life of LEGEE-668 is 5 (five) years from the date of purchase.
Robot’s serial number must be registered to receive limited warranty service.
You can register robot on official distributor’s web-site:
http://homerobotusa.com/hobot-register/
Or you can call us to register at 833.462.6887.
- 15 -
CE Declaration of Conformity
We herewith confirm the following designated products to comply with the requirements
set out in the Council Directive on the approximation of the laws of the Member States
relating to Electromagnetic Compatibility Directive (2014/30/EU) with applicable
standards listed below.
Product : Mopping Robot
Trade name : HOBOT
Model Number : LEGEE-668
Applicable Harmonized : EN 55014-1: 2006+A2: 2011
Standards under Directive EN 55014-2: 2015
2014/30/EU EN 61000-3-2: 2014, EN 61000-3-3: 2013
IEC 61000-4-2 Ed. 2.0: 2008, IEC 61000-4-3 Ed. 3.2: 2010
IEC 61000-4-4 Ed. 3.0: 2012, IEC 61000-4-5 Ed. 3.0: 2014
IEC 61000-4-6 Ed. 4.0: 2013, IEC 61000-4-11 Ed. 2.0: 2004
ERP Directive : Lot 7(278/2009) of (2009/125/EC)
Low Voltage Directive : 2006/95/EC and 2014/35/EU
RoHS 2.0(2011)/EU
Safety : IEC 60950-1: 2005+A1: 2009+A2: 2013
EN 60950-1: 2006+A11: 2009+A1: 2010+A12: 2011+A2:
2013
- 16 -