manual n19509g
TRANSCRIPT
Note: Crown position "A" "B" &"C" Note: Pusher "A" ( Top Right), Pusher 'B" ( Bottom Right) Note: 3 o'clock eye - 24 hour hand / diskNote: 6 o'clock eye - second handNote : 9 o'clock eye - stopwatch minute hand / disk
This Chronograph watch has three functions : TIME, CALENDAR, STOPWATCH
TIME To set the time: 1. Pull crown to position "C" 2. Turn crown clockwise / counter clockwise to correct time
A B C
Crown PosITIon
PUsHEr “B”
PUsHEr “A”
OS20 DATE
sToPwATCH MInUTE HAnD
sEConD HAnD
24 HoUr HAnD
sToPwATCH sEConD HAnD
A B C
Crown PosITIon
PUsHEr “B”
PUsHEr “A”
OS2B DATE
sToPwATCH MInUTE DIsk
sEConD HAnD
24 HoUr DIsk
sToPwATCH sEConD HAnD
3. Push crown to position "A"Remarks: When crown is pushed back to position "A," small second
hand begins to run.
CALEnDAr To set the calendar 1. Pull crown to position "B" 2. Turn crown counter-clockwise to set calendar 3. Push crown to position "A"
sToPwATCH The stopwatch is capable to measure and display time in 1/1 second united up to maximum of 59 minutes 59 seconds.
1. Press pusher "A" to start timing 2. Press pusher "A" again to stop timing 3. Press pusher "B" to reset
CorrECTInG sToPwATCH HAnD If after resetting the stopwatch second hand it is found that they are not at the '12' or '0' position, correct it as follows:
1. Pull crown to "C" position 2. Press pusher "A" continuously, the stopwatch second hand will be
advanced rapidly until it gets closely to the "12" position. Then, press pusher "A" repeatedly, the stopwatch second hand will be moved by interval until it returns to "12" position.
3. Push crown to position 'A"