mujahid ppt 1.pptx
TRANSCRIPT
![Page 1: MUJAHID PPT 1.pptx](https://reader035.vdocuments.net/reader035/viewer/2022070403/563db7db550346aa9a8e9a60/html5/thumbnails/1.jpg)
POWER UPGRADING OF TRANSMISSION LINE BY COMBINING AC-DC TRANSMISSION
GUIDED BY:
MR. GAURAV PANDEY
EE DEPT.
PRESENTED BY:
GROUP NO. 21 AMIT TRIPATHI MOHD. MUJAHID VINEET RANJAN
EE-7
4SR
MG
PC
![Page 2: MUJAHID PPT 1.pptx](https://reader035.vdocuments.net/reader035/viewer/2022070403/563db7db550346aa9a8e9a60/html5/thumbnails/2.jpg)
OVERVIEW
• OBJECTIVE
• INTRODUCTION
• SCHEMATIC DIAGRAM
• MATLAB SIMULINK MODELS
• SIMULATION GRAPHS
• ANALYSIS
• ADVANTAGES
• CONCLUSION
• PROJECT REVIEW
• BIBLIOGRAPHY1
![Page 3: MUJAHID PPT 1.pptx](https://reader035.vdocuments.net/reader035/viewer/2022070403/563db7db550346aa9a8e9a60/html5/thumbnails/3.jpg)
OBJECTIVE
• Power transfer enhancement , without any alteration in
the existing Extra High Voltage AC line.
• To utilize the advantage of parallel ac–dc transmission
by loading the line close to its upper thermal limit.
2
![Page 4: MUJAHID PPT 1.pptx](https://reader035.vdocuments.net/reader035/viewer/2022070403/563db7db550346aa9a8e9a60/html5/thumbnails/4.jpg)
INTRODUCTION
• Long extra high voltage (EHV) ac lines cannot be loaded to
their thermal limits in order to keep sufficient margin against
transient instability.
• In simultaneous ac-dc power transmission system, the
conductors are allowed to carry dc current superimposed on
ac current.
• The added power flow does not cause of any transient
instability.3
![Page 5: MUJAHID PPT 1.pptx](https://reader035.vdocuments.net/reader035/viewer/2022070403/563db7db550346aa9a8e9a60/html5/thumbnails/5.jpg)
4
BASIC SCHEME FOR COMPOSITE AC-DC TRANSMISSION
![Page 6: MUJAHID PPT 1.pptx](https://reader035.vdocuments.net/reader035/viewer/2022070403/563db7db550346aa9a8e9a60/html5/thumbnails/6.jpg)
SIMULATION OF EHV-AC TRANSMISSION
5
![Page 7: MUJAHID PPT 1.pptx](https://reader035.vdocuments.net/reader035/viewer/2022070403/563db7db550346aa9a8e9a60/html5/thumbnails/7.jpg)
SIMULATION OF EHVAC-DC TRANSMISSION
6
![Page 8: MUJAHID PPT 1.pptx](https://reader035.vdocuments.net/reader035/viewer/2022070403/563db7db550346aa9a8e9a60/html5/thumbnails/8.jpg)
DESIGN
• 115kV, 50Hz, 450 km D/C AC transmission line
• The total power transfer through the circuit line
sin /X
•AC current per phase per circuit of the line.
= V (sin /2)/X.
• Transfer reactance per phase, X = 74.4435 ohm/ph.
• Total power = + .
• Power transfer through AC-DC combined line
sin /X+ 2 .7
![Page 9: MUJAHID PPT 1.pptx](https://reader035.vdocuments.net/reader035/viewer/2022070403/563db7db550346aa9a8e9a60/html5/thumbnails/9.jpg)
8
SIMULATION OF RECTIFIER SIMULATION OF INVERTER
![Page 10: MUJAHID PPT 1.pptx](https://reader035.vdocuments.net/reader035/viewer/2022070403/563db7db550346aa9a8e9a60/html5/thumbnails/10.jpg)
AC FILTER
9
Reactive power , = (/ )·/(( – 1)
Tuned harmonic order, n= / .
Quality factor, Q = n /R = /(n R)
Where, fn – tuning frequency f1- fundamental frequency
![Page 11: MUJAHID PPT 1.pptx](https://reader035.vdocuments.net/reader035/viewer/2022070403/563db7db550346aa9a8e9a60/html5/thumbnails/11.jpg)
SIMULATION GRAPHS
10
AC ALONE:
• AC VOLTAGE: SENDING END, RECEIVING END
• AC CURRENT: SENDING END, RECEIVING END
• SENDING END POWER: ACTIVE, REACTIVE
• RECEIVING END POWER: ACTIVE, REACTIVE
AC-DC COMBINED:
• VOLTAGE: SENDING END, RECEIVING END
• CURRENT: SENDING END, RECEIVING END
• DC CURRENT: RECTIFIER, INVERTER
• SENDING END POWER: ACTIVE, REACTIVE
• RECEIVING END POWER: ACTIVE, REACTIVE
![Page 12: MUJAHID PPT 1.pptx](https://reader035.vdocuments.net/reader035/viewer/2022070403/563db7db550346aa9a8e9a60/html5/thumbnails/12.jpg)
ADVANTAGES
• Conductors can be loaded close to their thermal limit.
• The power flow does not impose any stability problem.
• No alterations of conductors, insulator strings or towers of the original line are needed.
• Helps to improve stability and damping out of oscillations.
11
![Page 13: MUJAHID PPT 1.pptx](https://reader035.vdocuments.net/reader035/viewer/2022070403/563db7db550346aa9a8e9a60/html5/thumbnails/13.jpg)
CONCLUSION
• The merits to convert existing double circuit ac transmission line to
composite ac-dc transmission line for substantial power upgrading
have been demonstrated.
• Studied that there is substantial increase in the load ability of the
line.
• The load ability further increases with increase in the length of line.
• The line is loaded near to its thermal limit with the superimposed dc
current.
• The capacity of the transmission line is increased by 85.06 % .12
![Page 14: MUJAHID PPT 1.pptx](https://reader035.vdocuments.net/reader035/viewer/2022070403/563db7db550346aa9a8e9a60/html5/thumbnails/14.jpg)
13
THANK YOU