T-Code:oonrSub Group IN / Ex Start End Status Ext01C (Job) =>EX- 20000000 - 29999999 - 0 - X (Check the Ext box)01O (Object) =>EX- 30000000 - 39999999 - 0 - X (Check the Ext box)01S (Position) =>EX - 40000000 - 49999999 - 0 - X (Check the Ext box)We set all the number ranges as external because you are uploading them throughLSMW(Legacy System Migration Workbench) through templates.

Hope this will help you,With warm regards,Srikanth Naidu. AkulaMessage was edited by: Sikindar AJun 1208

Re: OM implementation 08:40 // Suganya K

Dear Parveen,There are different ways to configure OM. You can follow any one of the below mentioned methods:Method T-Code DescriptionSimple Maintenance PPOC_OLDcreation of Org StructureSimple Maintenance PPOM_OLDmodification of Org StructureSimple Maintenance PPOS_OLD display/ View Org StructureExpert Mode PO10 creation of Org StructureExpert Mode PO13 creation PositionExpert ModePO03 creation of JobOrganization & Staffing PPOCE creation of Org StructureOrganization & Staffing PPOME Modification of Org StructureOrganization & Staffing PPOSE Display/ View Org StructureWe can also upload the objects O,C,S in OM through LSMW You can take the help of your ABAPer for the same.Internal / External No Ranges: use the Tcode OONR.Relationship : Person to Person relationship is not possible as for as i know.The possibilities are:Org unit Org unitOrg unit PositionOrg unit JobOrg unit Cost CenterIf you want to see the relationship descriptions use the tcodeOOVKBased on your requirement you can assign the relationship to objects