rear bumper removal installation
DESCRIPTION
Manual taller como Montar/Desmontar defensa trasera MAZDA2 DETRANSCRIPT
REAR BUMPER REMOVAL/INSTALLATIONid091000405300
1. Disconnect the negative battery cable.2. Remove the splash shield. (See SPLASH SHIELD REMOVAL/INSTALLATION)3. Remove the rear combination light. (See REAR COMBINATION LIGHT REMOVAL/INSTALLATION)4. Remove the fastener A.
REAR BUMPER
FASTENER A
am2zzw00001609
5. Remove the fasteners B.
FASTENER B
REAR BUMPER
am2zzw00001610
6. Remove the screws C.
SCREW C
REAR BUMPER
am2zzw00001611
7. Pull the rear bumper in the direction of arrow (1)shown in the figure to disengage the bumper fromthe rear bumper slider, then remove the rear bumperin the direction of arrow (2).
Caution• When disengaging the rear bumper from
the rear bumper slider, the rear bumpercould fall and be damaged. Support the rearbumper so that it does not fall.
8. Remove clips D,E and the license plate light bulb,then set aside the wiring harness to the vehicle side.
REAR BUMPER
(1)
(1)(2)
am2zzw00001612
LICENSE PLATE LIGHT BULB
CLIP D
CLIP D
REAR BUMPER
WIRING HARNESS
WIRING HARNESS
REAR BUMPER
CLIP E
CLIP E REAR BUMPER
am2zzw00001788
9. Disconnect the rear fog light connector. (Vehicles with rear fog light)10. Install in the reverse order of removal.
Rear Bumper Installation Note1. Spread the rear bumper ends apart.2. Assemble the rear bumper to the body.3. Press the rear bumper connecting area in the
direction of the arrow shown in the figure to engagewith the rear bumper slider.
REAR BUMPER SLIDER
REAR BUMPER
am2zzw00001613