rfcd lab report
TRANSCRIPT
Visvesvaraya National Institute Of Technology, Nagpur
RFCD LAB REPORT LOKESH GAHANE (MTCMN007)
Lab1Designing of Matching Networks
The objective of designing of matching networks is to transfer maximum power to load at the desired RF frequency i.e. 2.07 GHz in this experiment. To Transfer all the power to load, it is required that the matching network is lossless.
Figure shows L section matching network with circuit diagram, input impedance, scattering parameters and related calculations.
Here Zs = 50 ohm and Z(load) = 75 ohm
L MATCHING NETWORK:
RESULT:
CACULATIONS:
L MATCHING NETWORK:
RESULT:
CACULATIONS:
PAI MATCHING NETWORK:
RESULT:
CACULATIONS:
T MATCHING NETWORK:
RESULT:
CACULATIONS:
Lab2
Designing of Tapped Inductor and Capacitor
Tapped Capacitor and Tapped inductor are another important circuits for impedance matching in which four parameters are unknown such as L1, L2 and C as shown in figure 24 with RL=50 ohm and Rin=75 ohm.
TAPPED CAPACITOR:
RESULT:
CACULATIONS
TAPPED CAPACITOR:
RESULT:
CACULATIONS
Lab3Designing of Tapped Resonator
Tapped Resonator is another important circuit for impedance matching in which four parameters are unknown such as C1, C2, L1 and L2 as shown in figure 36 with RL=75 ohm and Rin=50 ohm.
CIRCUIT DIA:
RESULT:
CACULATIONS