www.condorsign.nl

Roll banner XXLInstructions

5. Insert the aluminum barsinto the attachment beam.

9. Peel o� the cover, remove thescrew underneath the chrome endof the base and detach. Then, withthe graphic held �rmly, carefullypull out the retaining pin, thenput it into the cover.

13. The bottom of the assembledpole slides into the round socketin the base unit.

14. Unfuri the banner out of thebase, suggest handling by twopersons.

15. Insert hook into pole on top. 16. Raise the upper pole.

10. Carefully allow the graphic torecoil into the base unit (it may beuseful to have an assistant hold thebase steady).

11. Reattach the chrome ends. 12. Two revolving feet to strengh-ten stability.

6. Make sure all the screws have been swung out, as the pic show.

7. Peel o� the adhesive cover alongthe edge of the base’s leader roll,and attach the bottom of the banner(front facing up).

8. Finish securing the banner to theleader with a strip of wide packingtape along the inside of the edge.

2. The case should contain abase unit, two telescopic polesand upper banner.

3. Peel o� the cover. You’ll get ascrewdriver in the cover and twotelescopig poles in the base unit.

4. Paste aluminium bars one byone upon the upper and downedges of the graphic.