site analyzer

8/14/2019 Site Analyzer

1/12

SITE ANALYZER TOP View


2/12

Side view of Site Analyzer


3/12

Description of all the Keys Used in site master

1. Soft KeysActivate the function described directly to the right ofthe key.

2. Hard Key

Mode -Activates the mode menu. Use this to select Measure Match,

Fault Location, Measure Power, or Utilities mode.

ConfigActivates the configuration menu for the current mode. Usethis to set variable parameters (e.g. frequency band, distance, andunits)

CalibrateActivates the calibration menu. MarkerActivates the marker menu. Use this to turn markers on or

off and to move the active marker.


4/12


5/12

6. Cursor Keys

Left Arrow

During:

Data EntryDeletes previously entered data one character at a time.

Marker UseMoves active marker left one point at a time.

All other timesAs defined by the function descriptionRight Arrow

During:

Marker UseMoves active marker right one point at a time.

All other timesAs defined by the function description


6/12

6. Cursor KeysUp Arrow

During:Data EntryIncrease the numeric value.

Marker UseMoves the marker to the maximum trace value.

While pressing the Contrast keyIncrease the display contrast.

All other timesAs defined by the function description.

Down ArrowDuring:

Data EntryDecrease the numeric value.

Marker UseMoves the marker to the minimum trace value.

While pressing the Contrast keyDecrease the display contrast.

All other timesAs defined by the function description


7/12

7. Battery LED

The Yellow LED lights when the unit is power from an external DC

power source. It blinks while charging the internal battery. Once the

battery is fully charged the yellow LED stops blinking. The green LED

lights whenever the unit is on.

8. Contrast KeyHold while pressing the up/down arrow keys to adjustthe contrast of the display.

9. I/O (On/Off)-Turns the instrument on and off. The key must be pressedfor at least onhalf (1/2) second.


8/12

Description of Different port in Site master

Antenna Test PortFemale N connector for connecting to theantenna. Use a phase-stable cable for best results.

Parallel Printers Port25-pin (DB9) parallel connector for connectingto HP- type inkjet printers. A printer cable is not included.

Computer/Power Sensor Port9 Pin RS-232 (DB9)serial connector forconnecting to a PC or to Bird power sensors.

DC InputInput for external power supplies. Plug either the ac powersupply or the cigarette lighter adapter into the dc input. The external

supplies operate the unit and charge the internal battery.


9/12


10/12

How site analyzer Calibrated

Step 1- Press the Calibrate key

Step 2- Connect the Cal Combo Open connector to the unit antennaport.

Step 3- Press the Open soft key then wait for the unit to beep anddisplay Done.

Step 4- Connect the Cal Combo Short connector to the unit antennaport.

Step 5- Press the Short soft key then wait for the unit to beep anddisplay Done.

Step 6- Connect the Cal Combo Load connector to the unit antennaport.

Step 7- Press the Load soft key then wait for the unit to beep anddisplay Done.

Step 8- Remove the Cal Combo from the unit.


11/12

How we select the measure match mode

Step 1- Turn On the Site Analyzer. Press ON/OFF key for second.

Step 2- Press the MODE key.

Step 3- Press the Measure Match key.

Frequencies can be set manually or chosen from a list of presets (band

lists). If the start, stop, center, or span frequency is manually set, the

band list will indicate Custom.


12/12

How we select the measurement Units

When making a match measurement, select one of three units for the Y

(vertical) scale.

VSWR (ratio)

Rtn Loss (dB)

Cbl Loss (dB)

site analyzer

Documents